Alternatives and similar repositories for pico-rmiieth

Users that are interested in pico-rmiieth are comparing it to the libraries listed below

• essele / rp2040-rmii
  An ethernet MAC implementation for the RP2040
  ☆27Updated 3 years ago
• deanm1278 / FPGA_SWD
  fpga co-processor for faster SWD programming
  ☆17Updated 8 years ago
• hansfbaier / ch569-usb3-board
  USB3 super speed development board useful as FPGA expansion based on WCH-Tech CH569
  ☆26Updated 2 years ago
• AddioElectronics / QSPI-Analyzer
  Analyzer for low level debugging of the QSPI Protocol, for use with Saleae and Kingst Logic Analyzers.
  ☆23Updated last year
• tmcqueen-materials / pio-i2c-hs
  RP2040 PIO I2C High Speed (3.4 Mbps) Implementation
  ☆25Updated 3 years ago
• prosper00 / CH32V305-DAPLink-HS
  CH32V305 DAPLink - USB2.0 High Speed DAPLink firmware for the WCH-LinkE
  ☆20Updated last year
• cortexprog / cortexprogfw
  ☆28Updated 5 years ago
• SoCXin / CH569
  L2 R6: WCH 120MHz RISC-V3A USB3.0 SoC (CH569)
  ☆16Updated 2 years ago
• asanza / gpib2usb
  simple gpib2usb adapter
  ☆12Updated 8 years ago
• HonghongLu / CH554
  8051 microcontroller
  ☆40Updated 7 years ago
• rgwan / open-ec
  Opensource embedded controller firmware for sipeed boards.
  ☆42Updated 6 years ago
• deadsy / rvdbg
  RISC-V Debugger
  ☆16Updated 6 months ago
• machdyne / atio
  RP2040 firmware for controlling GPIO over USB CDC with AT commands
  ☆12Updated 9 months ago
• markb139 / pico_logic
  Simple USBTMC & VXI capable, Raspberry Pi Pico logic analyser. Can work with Sigrok
  ☆18Updated 3 years ago
• ultraembedded / usb2sniffer
  USB2Sniffer: High Speed USB 2.0 capture (for LambdaConcept USB2Sniffer hardware)
  ☆57Updated 5 years ago
• kprasadvnsi / riscv-openocd-wch
  OpenOCD source code for CH32V series MCUs released by Mounriver IDE
  ☆55Updated 3 years ago
• cjacker / wchlinke-mode-switch
  Deprecated, use 'wlink' instead. Command line tool to switch WCH-LinkE modes between DAP and RV from host.
  ☆10Updated 10 months ago
• charkster / usb_pd_monitor
  USB PD cc pin monitor implemented in a Tang Nano 9K FPGA.
  ☆18Updated last year
• VladimirDuan / CH55x-USB-Blaster
  USB-Blaster instance on CH55x MCU.
  ☆50Updated 6 years ago
• michahoiting / rv-link
  RV-Link: In application debugger for RISC-V micro-controllers, RISC-V emulator, running on RISC-V development boards (e.g. Sipeed Longan …
  ☆31Updated 4 years ago
• cjacker / opensource-toolchain-bouffalo-lab
  Opensource toolchain for BL602/BL604, BL702/BL704/BL706, BL616/BL618, BL808 and other series of RISC-V based chips from Bouffalo Lab
  ☆24Updated 10 months ago
• dgatf / Pio-Pin-Capture-Timer-for-RP2040
  A pio program to capture signal edges on any pins of the RP2040
  ☆16Updated 2 months ago
• newbrain / riscv-openocd-wch
  This is the OpenOCD source code modified to support WCHlink and CH32Vxxx MCUs, received from MounRiver after my GPL request, and publishe…
  ☆18Updated 3 years ago
• NegasonicX / Raspberry-PICO2040-Flash-Storage
  The Following C Coded Library is used to perform Flash Write, Read and Erase functions on Raspberry Pico 2040.
  ☆31Updated 3 years ago
• kaidegit / CMSIS-DAPbyWCH
  a cheap CMSIS-DAP debugger by an WCH chip named CH549F
  ☆47Updated 4 years ago
• mithro / fx2-ftdi-emulation
  Firmware for the FX2 which emulates the FTDI serial chips (including MPSSE support).
  ☆15Updated 7 years ago
• dgatf / I2C-slave-multi-address-RP2040
  I2C slave protocol to answer to multiple addresses for the RP2040
  ☆25Updated last month
• openwch / ch569
  SDK sch&layout reference design and datasheet documention
  ☆64Updated last year
• jankae / battery-sim
  A voltage source imitating the behaviour of a battery
  ☆13Updated 6 years ago
• martinribelotta / imxrt1020-module
  iMX RT 1020 CPU module
  ☆34Updated 5 years ago