rusefi / kicad-librariesLinks
KiCAD library for rusEFI open source engine control unit
☆17Updated 2 years ago
Alternatives and similar repositories for kicad-libraries
Users that are interested in kicad-libraries are comparing it to the libraries listed below
Sorting:
- ☆26Updated last week
- Hellen-One Hardware Platform for rusEFI Engine Management System☆23Updated 2 weeks ago
- 8Ch EGT sensor board to be used with aftermarket ECUs☆32Updated last year
- Hardware - CAN enabled small input / output expansion board. Switch panels, steering wheel buttons/knobs, etc.☆39Updated 2 months ago
- User documentation for rusEFI engine control unit☆34Updated this week
- ☆40Updated 3 weeks ago
- microRusEfi board for rusEfi ECU☆76Updated 7 months ago
- ☆58Updated 3 weeks ago
- A fully custom infotainment system for my W211 E55 AMG based on a PC with a custom daughter board!☆32Updated 2 months ago
- Speeduino compatible engine control unit (ECU) based around black STM32F407VET6 board.☆50Updated last year
- Automatic Transmission Controller designed by Seaside Customs Garage☆12Updated 6 years ago
- The Three channel CAN board for Network integration Solutions☆13Updated 2 months ago
- Firmware - CAN enabled small input / output expansion board. Switch panels, steering wheel buttons/knobs, etc.☆13Updated 2 months ago
- Hardware - dingoPDM is an open source, affordable automotive PDM (Power Distribution Module). Pre-assembled and tested units are availabl…☆81Updated last week
- Free Open Motorsports ECU☆80Updated last week
- CANBUS implementation for ME7.5 with Arduino Nano and MCP2515☆20Updated 6 years ago
- ☆18Updated 5 years ago
- CAN interface for Raspberry Pi Zero☆10Updated 7 years ago
- Official and user contributed base tunes for Speeduino installations☆38Updated 4 months ago
- TunerPro definition file for BMW 6HPxx transmissions.☆24Updated 8 years ago
- ECUMaster Arduino Serial Library☆21Updated 4 years ago
- Wideband Lambda Controller with Bosch CJ125 and CAN-Bus Interface☆27Updated last year
- CAN-bus gauge cluster for BMW E12☆13Updated 2 years ago
- BMW CANbus gateway emulator & proxy☆19Updated 4 years ago
- Interactive Pinout Generator☆10Updated 8 months ago
- ECU designed for Speeduino firmware☆32Updated 5 years ago
- An open source engine management☆28Updated 5 months ago
- Arduino Nano based ETC controller implemented with working states☆10Updated 6 years ago
- A 75x78mm speeduino board featuring robotdyn mega 2560 pro microcontroller and all the basics needed to get a 2 channel setup. This is me…☆13Updated 3 years ago
- Standalone ECU designed for Speeduino and RusEFI firmware.☆40Updated last year