analoghan / CAN_GaugesLinks
Arduino/Teensy CAN Gauges with OLED displays
☆16Updated 7 years ago
Alternatives and similar repositories for CAN_Gauges
Users that are interested in CAN_Gauges are comparing it to the libraries listed below
Sorting:
- Hardware - CAN enabled small input / output expansion board. Switch panels, steering wheel buttons/knobs, etc.☆40Updated last week
- Speeduino compatible engine control unit (ECU) based around black STM32F407VET6 board.☆50Updated last year
- open-source ESP32-based control system designed to manage multiple outputs, monitor temperature, and provide robust control over external…☆16Updated 10 months ago
- ☆22Updated 7 years ago
- Megasquirt Gauge using CAN bus.☆35Updated 3 years ago
- Wideband Lambda Controller with Bosch CJ125☆40Updated last year
- ECUMaster EMU CAN Stream Reader Arduino Teensy 3 and 4 Library☆11Updated 2 years ago
- DS2 K-line library for Arduino and ESP32☆51Updated 4 months ago
- CAN-based Formula SAE / FSAE race car dashboard with data logging☆11Updated 5 years ago
- EMS boards powered by Speeduino☆12Updated last week
- Hardware - dingoPDM is an open source, affordable automotive PDM (Power Distribution Module). Pre-assembled and tested units are availabl…☆84Updated last week
- ☆130Updated 3 weeks ago
- Zero Motorcycles alternative dashboard using a tft and the canbus and an Adafruit Esp32☆14Updated 3 years ago
- Please find my custom Speeduino based ECU.☆18Updated 4 years ago
- CANbus shift light, works with Neopixels and MCP2515 to make a shiftlight that works over CAN.☆19Updated 6 months ago
- ☆43Updated 3 years ago
- ☆60Updated last week
- An OLED gauge for the Speeduino ECU. Uses UART (secondary serial) for communication.☆38Updated 2 years ago
- ECUMaster EMU CAN Stream Reader Arduino Library☆35Updated last week
- EMS boards powered by Speeduino☆92Updated 9 months ago
- Standalone ECU designed for Speeduino and RusEFI firmware.☆45Updated last year
- Wideband lambda controller based on bosch cj125☆12Updated 6 years ago
- An Arduino sketch for controlling a Bosch LSU 4.9 Wideband Lambda sensor with minimal parts☆81Updated 11 years ago
- ☆66Updated last year
- Firmware - CAN enabled small input / output expansion board. Switch panels, steering wheel buttons/knobs, etc.☆13Updated 4 months ago
- ☆11Updated 5 years ago
- mcp2515 canbus module to Monitor Canbus traffic☆40Updated last year
- 8Ch EGT sensor board to be used with aftermarket ECUs☆33Updated last year
- BMW CANbus gateway emulator & proxy☆21Updated 4 years ago
- Dash display project for Megasquirt ECUs based on ESP32 and EVE2☆32Updated 6 years ago