oxda / usb-cerealLinks
USB-Cereal is a powerful, fully open source development tool that simplifies testing, development, debugging, and manufacturing of devices that utilize USB-C. Using USB-C’s extended capabilities this unique hardware saves time and effort through simplified debug and factory log capture, as well as firmware update procedures.
☆105Updated 2 years ago
Alternatives and similar repositories for usb-cereal
Users that are interested in usb-cereal are comparing it to the libraries listed below
Sorting:
- Open Source Logic Analyzers and data Syphons☆79Updated 2 years ago
- microcontroller-based FPGA / JTAG programmer☆76Updated 5 months ago
- ☆85Updated 2 months ago
- Use SWD debugging over USB-C debug accessory mode☆38Updated last year
- eMMC WFBGA153 to microSD card adapter PCB☆60Updated last year
- Farpatch debugger software layer, backed by Black Magic☆52Updated 2 months ago
- 20 pin SWD/JTAG J-Link to 10 pin (0.1" and 0.05") reconfigurable Cortex-M header with power supply and TagConnect compatibility, as well …☆77Updated 2 months ago
- USB test instrument☆80Updated 9 months ago
- Debug and parallel trace hardware for CORTEX-M (FPGA + support code)☆150Updated last month
- Bus Pirate v5 Hardware☆64Updated 2 weeks ago
- USB test instrument☆128Updated 2 weeks ago
- Yet Another Picoprobe☆153Updated 3 months ago
- HydraUSB3 V1 is an open source developer kit for the WCH CH569 MCU to experiment with streaming / high-speed protocols(USB2 HS, USB3 SS, …☆32Updated last year
- USB PD sniffer☆190Updated last year
- Microchip's Lightweight USB Power Delivery Software Stack☆40Updated 2 years ago
- Firmware for Raspberry Pico to work as JTAG debugger using OpenOCD☆45Updated 2 months ago
- High Speed Data Acquisition over HDMI - RP2350 HSTX implementation☆141Updated last month
- ☆71Updated 3 years ago
- Version of the NXP MCU-Link Debug CMSIS-DAP Debug Probe.☆24Updated this week
- 2.5kV Isolator for the USB Power Rail☆52Updated 2 years ago
- ☆98Updated 3 years ago
- USB-PD charger as a programmable power supply.☆66Updated 4 years ago
- NGFF (M.2) edge connector footprints and symbols for KiCAD☆38Updated 5 years ago
- Hardware design files for the Black Magic Probe☆126Updated 2 years ago
- 32-bit RISC-V MCU CH32X035 built-in USB PD PHY☆59Updated 2 months ago
- Raspberry Pi Pico USB I/O Board☆79Updated 2 years ago
- The original, unmodified Segger RTT source files distributed with JLink☆35Updated 3 weeks ago
- SDK sch&layout reference design and datasheet documention☆60Updated last year
- Open Source Hardware JTAG/SWD/UART/SWO interface board☆35Updated 10 months ago
- ☆27Updated 4 years ago