Alternatives and similar repositories for chipwhisperer-husky

Users that are interested in chipwhisperer-husky are comparing it to the libraries listed below

• greatscottgadgets / cynthion-hardware
  USB test instrument
  ☆89Updated last year
• openwch / usb-jtag-spi
  Single-chip solution for Hi-speed USB2.0(480Mbps) JTAG/SPI Debugger based on RISC-V MCU CH32V30x/CH32V20x
  ☆118Updated 2 years ago
• viveris / jtag-boundary-scanner
  JTAG boundary scan debug & test tool.
  ☆167Updated last year
• DreamSourceLab / DSLogic-hdl
  An open source FPGA design for DSLogic
  ☆168Updated 11 years ago
• arm8686 / FT2232HL-Board
  USB to dual UART / SPI / I2C / JTAG / FIFO / Bit-Bang...
  ☆140Updated 2 years ago
• ngscopeclient / scopehal
  Test and measurement hardware abstraction library and protocol decodes. This is the library only. Most users should use scopehal-apps.
  ☆254Updated 2 weeks ago
• DreamSourceLab / DSLogic-fw
  An open source firmware design for DSLogic
  ☆101Updated 11 years ago
• blueskull / CH552-JTAG
  USB-JTAG Adapter Using CH552
  ☆70Updated 3 years ago
• wuxx / USB-HS-Bridge
  ☆94Updated 2 months ago
• joeltroughton / uSMU
  Credit card-sized, USB-powered 4 quadrant source-measure unit hardware and firmware
  ☆120Updated 5 months ago
• intergalaktik / bb3-cm4
  CM4 compatible MCU board
  ☆33Updated last year
• DreamSourceLab / DSLogic-fw-keil
  Initial version of DSLogic-fw based on keil
  ☆39Updated 11 years ago
• sipeed / RV-Debugger-BL702
  RV-Debugger-BL702 Project, an opensource debugger implement
  ☆209Updated last year
• cortexm / pyswd
  Python SWD Debugging library for ST-Link/V2
  ☆68Updated 9 months ago
• Fescron / universal-jlink-adapter
  20 pin SWD/JTAG J-Link to 10 pin (0.1" and 0.05") reconfigurable Cortex-M header with power supply and TagConnect compatibility, as well …
  ☆84Updated 7 months ago
• colinoflynn / pyjtagbs
  Python JTAG Boundary Scan tool
  ☆87Updated last year
• sbstnh / programmable_precision_resistor
  A SCPI programmable precision resistor
  ☆61Updated 2 weeks ago
• diegoherranz / steppenprobe
  Open Source Hardware JTAG/SWD/UART/SWO interface board
  ☆37Updated last year
• ElectronicCats / DAP-Cat-Programmer
  An Open-Source CMSIS-DAP Debug Probe based on DAPLink and USB bus convert and it can realize USB convert to serial interface based in CH5…
  ☆95Updated last year
• hydrausb3 / hydrausb3_fw
  HydraUSB3 (WCH CH569) open source test firmware / examples / libraries to experiment with streaming / high-speed protocols (USB2 HS, USB3…
  ☆84Updated 2 years ago
• eez-open / modular-psu-firmware
  Firmware for EEZ Bench Box 3 (BB3)
  ☆102Updated last year
• vanbwodonk / ft2232hl-jtag-clone
  Digilent JTAG clone hardware + eeprom firmware (.bin)
  ☆68Updated 3 years ago
• greatscottgadgets / apollo
  microcontroller-based FPGA / JTAG programmer
  ☆81Updated 11 months ago
• banxian / EDUReviver
  J-Link v10/v11/v12 USB exploit utility
  ☆101Updated last year
• blueskull / PicoGate
  A tiny FPGA core module based on GW1NZ-LV1, CH552 and SLG46580
  ☆26Updated 3 years ago
• ARM-software / PAF
  PAF (the Physical Attack Framework) is a framework for learning about physical attacks: fault injection and side channels
  ☆25Updated this week
• openwch / ch569
  SDK sch&layout reference design and datasheet documention
  ☆65Updated last year
• oxda / usb-cereal
  USB-Cereal is a powerful, fully open source development tool that simplifies testing, development, debugging, and manufacturing of device…
  ☆115Updated 2 years ago
• esynr3z / openocd-svd
  Standalone OpenOCD and CMSIS-SVD based peripheral register viewer written on Python
  ☆33Updated 6 years ago
• tom66 / scopeapp
  ☆31Updated 4 years ago