nebkat / xbee-cellular-ntrip-server
Digi XBee® Cellular Micropython NTRIP Server (for use with Ardusimple)
☆7Updated 6 years ago
Alternatives and similar repositories for xbee-cellular-ntrip-server:
Users that are interested in xbee-cellular-ntrip-server are comparing it to the libraries listed below
- DUAL or SINGLE GPS bridge between AgOpenGPS an GPS receiver. Works with 2 UBlox to calculate heading+roll. Corrects and filters. ESP32 + …☆41Updated last year
- Real time kinematics base station (ESP32 + ZED-F9P)☆35Updated 2 years ago
- An IO-PCB (two motor-driver/H-bridge, CAN, RS232, ADS1115, relay, ethernet, ardusimple f9p compatible connector) with an ESP32 for 12V po…☆38Updated 5 years ago
- AgOpenGPS V5 + V4 autosteer code for ESP32☆10Updated 2 years ago
- A GNSS FeatherWing incorporating the u-blox ZED-F9P. Provides access to the ZED-F9P's USB, I2C, UART1 and UART2 ports.☆23Updated 9 months ago
- fork for RTKbase https://github.com/Stefal/rtkbase. Tool used to create the raspberrypi.org Raspbian images☆21Updated 7 months ago
- The hardware and enclosure for the popular centimeter level RTK Facet GNSS receiver with built in display.☆20Updated 7 months ago
- Configuration and Programs for activating IMU data on Emlid Reach☆11Updated 7 years ago
- UM982 specific AgOpenGPS Firmware☆13Updated 6 months ago
- RTK-GPS/GNSS guidance for agriculture tractor by python code☆16Updated 3 years ago
- AG Rooftop controller with NTRIP client and IMU (ESP32 Controller)☆39Updated 6 years ago
- A guide on how to assemble a GNSS PPK RAWX Logger from an Adafruit Feather M0 Adalogger and a SparkFun GPS-RTK2 Board which incorporates …☆34Updated 5 years ago
- Centimeter precision GPS/GNSS using L1/L2/L5 signals broadcast over Bluetooth, WiFi, and Ethernet.☆31Updated this week
- Manual for RTK GNSS with low cost u-blox ZED-F9P receivers rover-base setup☆60Updated last year
- CLI tool to easily get NTRIP caster information☆33Updated 2 years ago
- Software to controll the tractor from AgOpenGPS☆28Updated 2 years ago
- Useful code to work with Ardusimple simpleRTK2B application board☆37Updated 3 years ago
- Section Control for AgOpenGPS for ESP32 supporting 16 sections and switches to remote AOG☆13Updated last year
- u-blox GNSS receiver library light weight for low power tracking application☆25Updated 4 years ago
- Esp32 RTK BaseStation - sends u-Blox ZED-F9P RTCM correction data to rtk2go.com NTRIP caster☆31Updated 2 years ago
- A raw data logger based on the u-blox ZED-F9P GNSS receiver intended for use with Precise Point Positioning (PPP) and Post-Processed Kine…☆11Updated 4 years ago
- Arduino sketches for the TinkerRTK base station and rover communicating over a WiFi network☆11Updated last year
- mosaicHAT+ GNSS antenna + Raspberry Pi + Touch display + Battery + Case☆31Updated 4 years ago
- Arduino and CMake library for communicating with MS4525DO pressure transducers.☆17Updated 2 years ago
- ESP32 XBee UART Interface☆101Updated 2 years ago
- Open source I2C based datalogger. The bigger, better cousin to the original serial OpenLog.☆24Updated last year
- This is the develoment space for a NMEA 2000 Voyage Data Recorder based on an ESP32 with CAN bus and SD card. The logger is using a SN65H…☆26Updated 4 years ago
- ☆23Updated 6 months ago
- ☆12Updated 3 weeks ago
- ☆12Updated 2 years ago