doppelgrau / esp32-f9p-io-boardLinks
An IO-PCB (two motor-driver/H-bridge, CAN, RS232, ADS1115, relay, ethernet, ardusimple f9p compatible connector) with an ESP32 for 12V power, three 15V tolerant analog inputs, three 5V tolerant inputs.
☆38Updated 5 years ago
Alternatives and similar repositories for esp32-f9p-io-board
Users that are interested in esp32-f9p-io-board are comparing it to the libraries listed below
Sorting:
- DUAL or SINGLE GPS bridge between AgOpenGPS an GPS receiver. Works with 2 UBlox to calculate heading+roll. Corrects and filters. ESP32 + …☆41Updated 2 years ago
- Software to controll the tractor from AgOpenGPS☆29Updated 2 years ago
- Advanced Autosteer Sketch for ESP32 - WiFi Version☆38Updated 6 years ago
- AG Rooftop controller with NTRIP client and IMU (ESP32 Controller)☆41Updated 6 years ago
- UM982 specific AgOpenGPS Firmware☆13Updated last week
- ☆24Updated 7 months ago
- CANbus to mqtt bridge using esp32☆45Updated 5 months ago
- Arduino Library for CAN Bed☆26Updated 4 years ago
- ESP32 high-speed flash data logger for IMU (accelerometer+gyro+magnetometer), GPS, pressure sensor readings.☆20Updated 5 years ago
- ☆92Updated 7 years ago
- AgOpenGPS rate control.☆36Updated this week
- PID Controller using RTOS timers, based on Brett Beauregard's blog posts☆20Updated 4 years ago
- OpenIMU - Open Hardware Mini Logger based on ESP32☆42Updated 2 years ago
- small, cheap IO board on CAN bus. CC-BY 4.0☆10Updated 6 years ago
- Digi XBee® Cellular Micropython NTRIP Server (for use with Ardusimple)☆7Updated 6 years ago
- ☆15Updated last month
- Arduino-compatible library for battery management system based on Texas Instruments bq769x0 analog frontend (bq76920, bq76930 and bq76940…☆45Updated 2 months ago
- ☆10Updated last month
- Arduino ESP32 library supporting the on-chip CAN module☆12Updated 2 years ago
- ESP32 slcan compatible device☆101Updated 3 years ago
- Real time kinematics base station (ESP32 + ZED-F9P)☆35Updated 2 years ago
- CANbus to USB bridge using esp32☆30Updated last week
- A Qt C++ port of BrianT's AgOpenGPS☆42Updated 2 months ago
- Script for transferring section control and speed data between AgOpenGPS and Bogballe spreaders☆16Updated 2 months ago
- ☆14Updated 8 years ago
- A simple j1939 communication library for Arduino☆14Updated 3 years ago
- Autosteering and RTK-GNSS units for AgOpenGPS / QtOpenGuidance☆61Updated 2 years ago
- An ESP32 CAN 2.0B library☆63Updated 2 months ago
- Monitor the status of your Smart electric drive EV with Blynk☆27Updated 2 years ago
- fork for RTKbase https://github.com/Stefal/rtkbase. Tool used to create the raspberrypi.org Raspbian images☆22Updated 8 months ago