guannan-he / Antminer_s9_pynqLinks
transplant several overlays to s9_pynq board
☆14Updated 5 years ago
Alternatives and similar repositories for Antminer_s9_pynq
Users that are interested in Antminer_s9_pynq are comparing it to the libraries listed below
Sorting:
- ☆79Updated 6 years ago
- 蚂蚁S9矿板移植pynq2.5☆36Updated 5 years ago
- CH55x USB to JTAG bridge☆141Updated 8 months ago
- FT2232D emulator☆35Updated last year
- A tiny FPGA core module based on GW1NZ-LV1, CH552 and SLG46580☆26Updated 3 years ago
- USB-JTAG Adapter Using CH552☆70Updated 3 years ago
- ☆25Updated 4 years ago
- A low cost FPGA/CPLD dev-board based on AG1280Q48.☆70Updated 5 months ago
- Single-chip solution for Hi-speed USB2.0(480Mbps) JTAG/SPI Debugger based on RISC-V MCU CH32V30x/CH32V20x☆118Updated 2 years ago
- ☆19Updated last year
- USB-Blaster instance on CH55x MCU.☆52Updated 6 years ago
- CH347 Xilinx Virtual Cable☆28Updated 3 months ago
- A far more light version anlogic-jtag cable with some enhanced functions.☆52Updated last year
- AGRV2K裸奔测试工程☆28Updated last year
- FPGA core boards / evaluation boards based on CDCTL hardware☆93Updated 4 years ago
- L4:Cortex A5 GSM SoC RDA8810☆25Updated 6 years ago
- Load bitstream to AG1K series FPGA using CH552☆12Updated 4 years ago
- Communication channel from FPGA (Alterra EP4CE10) and Linux (Lichee PI Allwinner V3S)☆28Updated 5 years ago
- CH552 Dual USB to Serial Bridge.☆79Updated last year
- RV-Debugger-BL702 Project, an opensource debugger implement☆210Updated last year
- Altera "USB_Blaster" clone using Teensy 3.5 microcontroller☆21Updated 5 years ago
- Digilent JTAG clone hardware + eeprom firmware (.bin)☆70Updated 3 years ago
- Opensource embedded controller firmware for sipeed boards.☆44Updated 6 years ago
- FTDI EEPROM dumps for common JTAG FPGA programmers☆88Updated 2 years ago
- Binary blob for Anlogic USB-JTAG adapter (temporary), We should figure out much better solution next year.☆18Updated 7 years ago
- simple DSO over Wi-Fi☆112Updated 9 years ago
- The program for USB-Blaster Chinese version on STM32 works with☆33Updated 8 years ago
- Use gpio to emulate usb low-speed on stm32f030f4p6.Use internal rc instead of crystal.☆35Updated 8 years ago
- Wireless JTAG 'cable' for Xilinx FPGAs. This is an 'English fork' of https://github.com/ciniml/xvc-esp32 project.☆123Updated 4 years ago
- Simple mono FM Radio.☆49Updated 9 years ago