JAndrassy / RegulatorLinks
DIY Arduino consumption regulator build to use excess solar power for auxiliary 'summer' heating. The solar power data are retrieved over SunSpec Modbus TCP. IoT monitoring with Blynk and local Web server.
☆54Updated 7 months ago
Alternatives and similar repositories for Regulator
Users that are interested in Regulator are comparing it to the libraries listed below
Sorting:
- A Modbus RTU (RS-485) to MQTT Gateway (based on ESP32)☆90Updated last year
- A very flexible ESP32 power meter / energy meter with SCT-013-0x0, ZMPT101B, ACS712 sensors☆43Updated last year
- ☆44Updated 3 years ago
- Device to measure energy and temperature☆80Updated 6 years ago
- An M-bus master that poll a meter and logs data to an MQTT server☆52Updated 9 years ago
- ☆30Updated 3 years ago
- This project is for connecting to EPEver charge controllers over WiFi for viewing running stats and also allows automatic posting of them…☆72Updated 10 months ago
- ☆62Updated 6 years ago
- Automate your home with GoWired open source modules designed for wired communication.☆40Updated last year
- 433MHz to MQTT Gateway using RFlink, Arduino Mega, and ESP8266☆46Updated 5 years ago
- Beca thermostat Modbus to MQTT Gateway☆16Updated 2 years ago
- ESP32 bridge allowing Daly Smart BMS to be used with a Sofar inverter/charger (and others that use SMA CANBUS protocol).☆33Updated last year
- An arduino sketch to connect the EPSolar/EPEver Tracer A/B Series (RS-485 Modbus) to an ESP8266 and monitor using the Blynk mobile app.☆65Updated 6 years ago
- Reads data from the Sage BMS console port and publishes to MQTT☆27Updated 3 months ago
- Code to read the VE.Direct-Protocol from serial into a value array. Uses a non-blocking read loop and does checksum verification before a…☆129Updated 3 years ago
- Open-source Heatpump Monitor☆77Updated last year
- Arduino library : control power rate on big AC load with Triac or SSR in safe way without EMI using Bresenham algorithm. Good for big res…☆19Updated 8 years ago
- EmonTx V3.4.x Hardware and older discreet firmware, see EmonTxV3CM repo for latest☆61Updated 11 months ago
- esp8266 IoT to mqtt bridge. Eastron SDM220, SDM230, SDM630 modbus; AZ7798; SenseAir s8; BME280; HDC1080; Plantower PMS5003, PMS7003, PMSA…☆20Updated 3 years ago
- ATtiny85 based LoRa atmospheric sensor board with BME280☆28Updated 6 years ago
- Program for reading data from a Xiaoxiang smart BMS and printing to an OLED display☆21Updated 4 years ago
- Communicating with Victron energy products, also compatible with other inverters and solar equipement☆19Updated 7 years ago
- EPSolar Solar Charge Controller to MQTT☆43Updated 3 years ago
- esp8266 IoT to mqtt bridge. Eastron SDM220, SDM230, SDM630 modbus; AZ7798; SenseAir s8; BME280; HDC1080; Plantower PMS5003, PMS7003, PMSA…☆56Updated 6 years ago
- Read and Write Library for Overkill Solar BMSs☆17Updated 2 years ago
- Lora Soil Moisture Sensor☆58Updated 2 years ago
- esp32 port of modbus RTU to TCP Arduino gateway☆68Updated 3 years ago
- 1CH MQTT WiFi Relay/Thermostat Board☆31Updated 2 years ago
- Code for varios IoT devices☆64Updated 5 years ago
- This is the library of the KNX-User-Forum Arduino project initiated by thorsten Gehrig☆52Updated last month