physee / Victron.Arduino-ESP8266
Code to read the VE.Direct-Protocol from serial into a value array. Uses a non-blocking read loop and does checksum verification before adding the data.
☆127Updated 3 years ago
Alternatives and similar repositories for Victron.Arduino-ESP8266:
Users that are interested in Victron.Arduino-ESP8266 are comparing it to the libraries listed below
- Lightweight arduino library to read basic data using the VE.Direct protocol from Victron Energy☆89Updated 2 years ago
- Read data from victron mppt and transport to mqtt server☆41Updated 2 years ago
- Use an ESP8266 to read live-, statistical- and status-data from an EpEver LandStar (LS1024B) via Modbus and publish using MQTT☆33Updated 6 years ago
- Use a esp32 to push VE.Direct ASCII messages to a MQTT server☆60Updated last year
- ☆29Updated 2 years ago
- ☆32Updated 9 months ago
- reading SDM72 SDM120 SDM220 SDM230 SDM630 modbus energy meters from arduino (esp8266, esp32, avr)☆253Updated 8 months ago
- ESPHome component to simulate the current clamp to control the Soyosource GTN1200 limiter☆82Updated 3 weeks ago
- Connect the EPSolar/EPEver Tracer A/B Series (RS-485 Modbus) to an ESP8266/ESP32 and monitor using Blynk /Homeassistant/MQTT... .☆53Updated 6 months ago
- EPSolar Solar Charge Controller to MQTT☆43Updated 3 years ago
- ESPHome component to monitor and control a Xiaoxiang Battery Management System (JBD-BMS) via UART-TTL or BLE☆143Updated last month
- ESP82XX based connector for EPEver Solar tracker systems, control and watch Multiple devices over webinterface and MQTT☆52Updated this week
- An arduino sketch to connect the EPSolar/EPEver Tracer A/B Series (RS-485 Modbus) to an ESP8266 and monitor using the Blynk mobile app - …☆59Updated 4 years ago
- Victron Mppt charger ve.direct to esphome node☆337Updated last month
- ESP8266 Connector to get Daly / XENES / HI-BMS / BullTron BMS Data into MQTT systems☆162Updated this week
- esp8266 IoT to mqtt bridge. Eastron SDM220, SDM230, SDM630 modbus; AZ7798; SenseAir s8; BME280; HDC1080; Plantower PMS5003, PMS7003, PMSA…☆20Updated 3 years ago
- Home Assistant / Domoticz tested with a RFLink, modified for ESP8266 and ESP32☆109Updated 3 years ago
- This project is for connecting to EPEver charge controllers over WiFi for viewing running stats and also allows automatic posting of them…☆71Updated 8 months ago
- Program to read out and display data from xiaoxiang Smart BMS over Bluetooth Low Energy☆104Updated 7 months ago
- M-Bus gateway with web server based on ESP8266 NodeMCU☆26Updated 5 months ago
- ☆102Updated last year
- Little Program for ESP82XX to get the Victron data to web and MQTT☆68Updated this week
- Adding WiFi monitoring to US2000B and US2000C batteries.☆144Updated 2 years ago
- Use official Victron BLE endpoint for fetching data from Victron devices via Bluetooth LE via ESPHome.☆255Updated 2 weeks ago
- SmartShunt ve.direct to ESPHOME node☆71Updated last year
- Readout of EMS protocol datagrams and transfer of data to Domoticz via Arduino☆90Updated 4 years ago
- Contains an Arduino project for Espressif ESP32 that will run a web server with web sockets to display data from a Victron MPPT charge co…☆26Updated 4 years ago
- Tasmota unofficial firmware builds. Install via Tasmota WebInstaller☆100Updated this week
- An arduino sketch to connect the EPSolar/EPEver Tracer A/B Series (RS-485 Modbus) to an ESP8266 and monitor using the Blynk mobile app.☆66Updated 5 years ago
- Tasmota Fork TCS34725,PN532_i2,ccc1101 Moritz support,m5stack 4,7 epaper, bresser 868 Mhz sensors and wether stations, loadable binary …☆28Updated this week