chickey / RS485-WiFi-EPEverLinks
This project is for connecting to EPEver charge controllers over WiFi for viewing running stats and also allows automatic posting of them to InfluxDB or MQTT.
☆74Updated last year
Alternatives and similar repositories for RS485-WiFi-EPEver
Users that are interested in RS485-WiFi-EPEver are comparing it to the libraries listed below
Sorting:
- Use an ESP8266 to read live-, statistical- and status-data from an EpEver LandStar (LS1024B) via Modbus and publish using MQTT☆32Updated 7 years ago
- ESP82XX based connector for EPEver Solar tracker systems, control and watch Multiple devices over webinterface and MQTT☆64Updated 4 months ago
- A node red based dashboard for most EPEver/EPSolar solar charge controllers.☆68Updated 2 years ago
- Connect the EPSolar/EPEver Tracer A/B Series (RS-485 Modbus) to an ESP8266/ESP32 and monitor using Blynk /Homeassistant/MQTT... .☆57Updated 2 months ago
- ESPHome component to simulate the current clamp to control the Soyosource GTN1200 limiter☆95Updated last month
- Tasmota unofficial firmware builds. Install via Tasmota WebInstaller☆120Updated this week
- M-Bus gateway with web server based on ESP8266 NodeMCU☆28Updated 8 months ago
- Device to measure energy and temperature☆81Updated 6 years ago
- Growatt Inverter monitoring via MQTT using ESP8266 modbus interface☆69Updated 5 years ago
- ESP8266 Connector to get Daly / XENES / HI-BMS / BullTron BMS Data into MQTT systems☆177Updated 4 months ago
- Read data from victron mppt and transport to mqtt server☆42Updated 3 years ago
- Program to read out and display data from xiaoxiang Smart BMS over Bluetooth Low Energy☆117Updated last year
- Contains an Arduino project for Espressif ESP32 that will run a web server with web sockets to display data from a Victron MPPT charge co…☆28Updated 5 years ago
- ESPHome component to monitor and control a Xiaoxiang Battery Management System (JBD-BMS) via UART-TTL or BLE☆199Updated last month
- Code to read the VE.Direct-Protocol from serial into a value array. Uses a non-blocking read loop and does checksum verification before a…☆131Updated 4 years ago
- A very flexible ESP32 power meter / energy meter with SCT-013-0x0, ZMPT101B, ACS712 sensors☆46Updated 2 years ago
- RFLink for ESP, with MQTT client☆75Updated 2 years ago
- OpenTherm library to create thermostat for OpenTherm enabled boilers and HVACs using an OpenTherm controller and an ESP32 or other microc…☆72Updated 3 years ago
- Simple library for Arduino (ESP32) to control a Chinese diesel heater through 433 MHz RF☆105Updated 5 years ago
- Bresser 5-in-1/6-in-1/7-in-1 868 MHz Weather Sensor Radio Receiver for Arduino based on CC1101, SX1276/RFM95W, SX1262 or LR1121☆161Updated last week
- ☆103Updated last year
- Home Assistant / Domoticz tested with a RFLink, modified for ESP8266 and ESP32☆110Updated 4 years ago
- ESP32 OpenTherm Wi-Fi Thermostat☆63Updated last year
- ESPHome component to monitor and control some Atorch meters via bluetooth☆88Updated last month
- ☆15Updated 8 years ago
- JBD BMS Linux utility☆70Updated 7 months ago
- ESPHome component to monitor and control a ANT-BMS via UART☆64Updated last month
- Converts the JK-BMS RS485 data to Pylontech CAN data☆98Updated 9 months ago
- reading SDM72 SDM120 SDM220 SDM230 SDM630 modbus energy meters from arduino (esp8266, esp32, avr)☆258Updated last year
- ESPHome component to emulate a SMA/Victron compatible BMS via CAN bus☆16Updated last month