merlokk / SmartHomeLinks
esp8266 IoT to mqtt bridge. Eastron SDM220, SDM230, SDM630 modbus; AZ7798; SenseAir s8; BME280; HDC1080; Plantower PMS5003, PMS7003, PMSA003
☆56Updated 7 years ago
Alternatives and similar repositories for SmartHome
Users that are interested in SmartHome are comparing it to the libraries listed below
Sorting:
- Device to measure energy and temperature☆82Updated 6 years ago
- Automate your home with GoWired open source modules designed for wired communication.☆41Updated 2 years ago
- ESP8266 WIFI serial to emoncms link☆166Updated 2 years ago
- ☆24Updated 8 years ago
- A class to collect data from a energy monitor that uses modbus protocol.☆47Updated 5 years ago
- Arduino communication library for Peacefair PZEM-004T Energy monitor☆239Updated 4 years ago
- An ESP8266 WiFi accessible serial port☆46Updated 10 years ago
- Plugin for a rapid development of battery-powered sensors☆133Updated 3 years ago
- Energy monitor with dashboard/metrics collector based on ESP32 controller and PeaceFair PZEM-004T/PZEM-004Tv30 Power Meter☆73Updated 10 months ago
- Plugin ideas, concepts, user contributed, etc☆193Updated last year
- ☆27Updated 8 years ago
- Single relay with ds18b20 sensor for TI cc2530 and Sonoff Zigbee☆66Updated last year
- ESPHome support for cheap WiFi PIR sensors☆67Updated 4 years ago
- ESPiLight - pilight 433.92 MHz protocols library for Arduino☆121Updated 2 years ago
- ☆68Updated 6 years ago
- 1CH MQTT WiFi Relay/Thermostat Board☆31Updated 2 years ago
- Take raw IR signal from a remote receiver and print out pulse lengths☆79Updated 8 months ago
- Provide ESP32 with Web, MQTT and OTA firmware using Arduino IDE or PlatformIO☆71Updated 7 years ago
- ESP8266-based smart wall switch☆132Updated 7 years ago
- ☆16Updated 6 years ago
- IOT-Light-Dimmer☆74Updated 5 years ago
- Full-featured Serial bridge for ESP8266, supports MQTT, WebSockets,Telnet, and also comes with a nice Config Page☆40Updated 2 years ago
- ESP8266 MQTT SDM ModBus Energy Meter☆22Updated 7 years ago
- ESP8266 with W5500 ethernet running as a gateway for ESP-Now nodes. Node demo code included.☆69Updated 7 years ago
- Home Assistant / Domoticz tested with a RFLink, modified for ESP8266 and ESP32☆110Updated 4 years ago
- ☆66Updated 7 years ago
- RFLink for ESP, with MQTT client☆75Updated 2 years ago
- MiniESP for ESP01 and modules with few pins, enables GPIO 1/3 disables Serial output.☆30Updated 9 years ago
- Domoticz remote controll with the nextion display☆11Updated 7 years ago
- Arduino EspNow managed flooding mesh network with mqtt☆74Updated 4 years ago