jomjol / water-meter-picture-providerLinks
☆44Updated 3 years ago
Alternatives and similar repositories for water-meter-picture-provider
Users that are interested in water-meter-picture-provider are comparing it to the libraries listed below
Sorting:
- ESPiLight - pilight 433.92 MHz protocols library for Arduino☆121Updated 2 years ago
- Home Assistant / Domoticz tested with a RFLink, modified for ESP8266 and ESP32☆110Updated 4 years ago
- reading SDM72 SDM120 SDM220 SDM230 SDM630 modbus energy meters from arduino (esp8266, esp32, avr)☆259Updated last year
- RF433Mhz decoding library☆61Updated 2 years ago
- Device to measure energy and temperature☆82Updated 6 years ago
- Provide ESP32 with Web, MQTT and OTA firmware using Arduino IDE or PlatformIO☆71Updated 7 years ago
- Connect the EPSolar/EPEver Tracer A/B Series (RS-485 Modbus) to an ESP8266/ESP32 and monitor using Blynk /Homeassistant/MQTT... .☆57Updated last month
- Code for varios IoT devices☆65Updated 6 years ago
- ESP8266 MQTT SDM ModBus Energy Meter☆22Updated 7 years ago
- Plugin for a rapid development of battery-powered sensors☆133Updated 3 years ago
- IOT-Light-Dimmer☆73Updated 5 years ago
- MQTT 433.92 MHz radio-frequency device gateway☆138Updated 3 years ago
- ESP8266 WIFI serial to emoncms link☆166Updated 2 years ago
- ESPHome support for cheap WiFi PIR sensors☆67Updated 4 years ago
- My personal Workspace for Mysensors HW☆35Updated 5 years ago
- Plugin ideas, concepts, user contributed, etc☆193Updated last year
- Software for the ESP8266 that sends P1 smart meter data to Domoticz (with CRC checking)☆83Updated 7 years ago
- All about the MicroWakeupper Library (and BatteryShield for the Wemos D1 Mini)☆41Updated last year
- A library that provides tools to simplify MQTT discovery implementation for Home Assistant to your device.☆47Updated last year
- Sonoff IR remote controll extension☆58Updated 8 years ago
- Battery powered door and window sensor with ultra low standby power. Arduino, ESP-12, Reed switch, ATtiny, LDO☆173Updated 8 years ago
- ☆24Updated 8 years ago
- MQTT 3.1.1 client library for the Espressif devices ESP8266 and ESP32 on the Arduino framework.☆119Updated last month
- Squeezebox player for ESP32 board☆117Updated 6 years ago
- ☆206Updated 3 years ago
- Code to wake up ESP8266 using external interrupt and send a MQTT message and turn itself off after external signal has vanished.☆27Updated 7 years ago
- The following library is used for work with dimmer, it gives ability to control large ammoun of dimmer. This lib uses with Leonardo, Mega…☆276Updated 2 years ago
- PangolinMQTT - ArduinoIDE client library for ESP8266, ESP32 and STM32-NUCLEO☆72Updated 4 years ago
- Code to read the VE.Direct-Protocol from serial into a value array. Uses a non-blocking read loop and does checksum verification before a…☆131Updated 4 years ago
- A very flexible ESP32 power meter / energy meter with SCT-013-0x0, ZMPT101B, ACS712 sensors☆45Updated 2 years ago