taligentx / dscKeybusInterface-RTOSLinks
An esp-open-rtos library to directly interface with DSC security systems, including native HomeKit support.
☆18Updated 6 years ago
Alternatives and similar repositories for dscKeybusInterface-RTOS
Users that are interested in dscKeybusInterface-RTOS are comparing it to the libraries listed below
Sorting:
- An Arduino/esp8266/esp32 library to directly interface with DSC security systems.☆584Updated last year
- Device to measure energy and temperature☆81Updated 6 years ago
- EPSolar Solar Charge Controller to MQTT☆44Updated 4 years ago
- Livolo light switch firmware☆22Updated 8 years ago
- Code to read the VE.Direct-Protocol from serial into a value array. Uses a non-blocking read loop and does checksum verification before a…☆131Updated 4 years ago
- Home Assistant / Domoticz tested with a RFLink, modified for ESP8266 and ESP32☆110Updated 4 years ago
- Arduino library and hardware shield to send and receive data from Opentherm devices☆182Updated 2 years ago
- This project is for connecting to EPEver charge controllers over WiFi for viewing running stats and also allows automatic posting of them…☆74Updated last year
- 433MHz temperature and humidity sensor receiver that integrates with home automation systems.☆194Updated 2 years ago
- Split Single-phase Energy Meter☆288Updated last year
- ESP8266 WIFI serial to emoncms link☆169Updated 2 years ago
- Plugin ideas, concepts, user contributed, etc☆195Updated last year
- Arduino code to send SMS notifications and events via WIFI for Paradox Home Security system☆13Updated 6 years ago
- ☆17Updated 8 years ago
- ESPHome support for cheap WiFi PIR sensors☆68Updated 4 years ago
- Take raw IR signal from a remote receiver and print out pulse lengths☆83Updated 10 months ago
- Bridge from RFLink to an mqtt broker using ESP8266 programmed with arduino IDE☆38Updated 7 years ago
- M-Bus gateway with web server based on ESP8266 NodeMCU☆28Updated 9 months ago
- RF433Mhz decoding library☆61Updated 2 years ago
- Alternative Firmware for the Sonoff RF Bridge EFM8BB1 chip☆302Updated 3 years ago
- Python-based IP150 'middle-ware' that uses the IP module's software port for monitoring and control of the alarm via an MQTT Broker.☆72Updated 5 years ago
- JBD BMS and Thornwave bluetooth data monitoring☆49Updated 4 years ago
- Zigbee light switch with dim support base on chip cc2530☆93Updated 5 years ago
- esp8266 IoT to mqtt bridge. Eastron SDM220, SDM230, SDM630 modbus; AZ7798; SenseAir s8; BME280; HDC1080; Plantower PMS5003, PMS7003, PMSA…☆57Updated 7 years ago
- Publish info from RTL433 receiver to MQTT broker☆99Updated 9 months ago
- reading SDM72 SDM120 SDM220 SDM230 SDM630 modbus energy meters from arduino (esp8266, esp32, avr)☆259Updated last year
- OpenTherm library to create thermostat for OpenTherm enabled boilers and HVACs using an OpenTherm controller and an ESP32 or other microc…☆74Updated 3 years ago
- Sketch and libraries to allow Arduino to act as a virtual Keypad for a DSC Powerseries 18XX alarm panel☆29Updated 9 years ago
- RFLink for ESP, with MQTT client☆75Updated 2 years ago
- esp8266, serial bus to mqtt for Paradox alarm systems☆81Updated 3 years ago