CircuitSetup / Split-Single-Phase-Energy-MeterLinks
Split Single-phase Energy Meter
☆285Updated 10 months ago
Alternatives and similar repositories for Split-Single-Phase-Energy-Meter
Users that are interested in Split-Single-Phase-Energy-Meter are comparing it to the libraries listed below
Sorting:
- Hardware & Software documentation for the CircuitSetup Expandable 6 Channel ESP32 Energy Meter. Works with ESPHome and Home Assistant.☆628Updated last month
- Whole home power monitoring with ESPHome - 6 Channels & 2 Channels☆112Updated 4 years ago
- Provide ESP32 with Web, MQTT and OTA firmware using Arduino IDE or PlatformIO☆71Updated 7 years ago
- ☆55Updated last year
- reading SDM72 SDM120 SDM220 SDM230 SDM630 modbus energy meters from arduino (esp8266, esp32, avr)☆259Updated last year
- ESP8266 WIFI serial to emoncms link☆166Updated 2 years ago
- Code for varios IoT devices☆65Updated 6 years ago
- Cheap power monitor (STC013) with Home Assistant Discover and Wemos D1 Mini / PRO (esp8266)☆121Updated 4 years ago
- OpenSprinkler Hardware Design files☆73Updated last month
- ESP32 IoT development board with 100Mb Ethernet and 802.3 Power Over Ethernet (POE)☆359Updated last week
- Multiple phase DIY energy consumption monitor using ESP32 and ESPHome☆218Updated last month
- Updated version of the ATM90E32 Arduino library☆31Updated 2 years ago
- ☆100Updated 8 months ago
- ESP32 Power Over Ethernet board with 3000VDC Galvanic insulation☆125Updated last week
- ☆103Updated last year
- An ESP32 arduino sketch that searches for a compatible Airthings device and publishes the radon level, temperature, and humidity to an MQ…☆26Updated 4 years ago
- ESP8266 MQTT Roomba controller (Useful for hooking up old Roombas to Home Assistant)☆214Updated 5 years ago
- An all-in-one remote based on the ESP32-WROOM-32E☆158Updated 3 months ago
- ESPHome support for cheap WiFi PIR sensors☆67Updated 4 years ago
- Alternative Firmware for the Sonoff RF Bridge EFM8BB1 chip☆300Updated 3 years ago
- Device to measure energy and temperature☆82Updated 6 years ago
- ALL-IN-ONE Irrigation and monitoring system for ESPHome and Home Assistant.☆192Updated 3 months ago
- Garden irrigation based on Sonoff 4ch, with built-in Nextion display☆155Updated 2 years ago
- Arduino library and hardware shield to send and receive data from Opentherm devices☆179Updated 2 years ago
- ☆56Updated last year
- My personal Workspace for Mysensors HW☆35Updated 5 years ago
- Code to read the VE.Direct-Protocol from serial into a value array. Uses a non-blocking read loop and does checksum verification before a…☆131Updated 4 years ago
- Growatt Inverter monitoring via MQTT using ESP8266 modbus interface☆68Updated 5 years ago
- ESP8266 WLAN Control Unit for Gardena 9V Irrigation Valve No. 1251☆37Updated last year
- Add Home Assistant support to your RDTech power supply☆50Updated 8 months ago