rhx / RF-Bridge-EFM8BB1
☆17Updated 7 years ago
Alternatives and similar repositories for RF-Bridge-EFM8BB1:
Users that are interested in RF-Bridge-EFM8BB1 are comparing it to the libraries listed below
- My personal Workspace for Mysensors HW☆34Updated 5 years ago
- Bridge from RFLink to an mqtt broker using ESP8266 programmed with arduino IDE☆38Updated 7 years ago
- ESPHome support for cheap WiFi PIR sensors☆67Updated 3 years ago
- MQTT 433.92 MHz radio-frequency device gateway☆137Updated 2 years ago
- RF433Mhz decoding library☆61Updated 2 years ago
- ESP8266 WeMos Shield for RFLink + OLED☆18Updated 5 years ago
- Home Assistant / Domoticz tested with a RFLink, modified for ESP8266 and ESP32☆109Updated 3 years ago
- 433mhz rf sniffer and receiver☆118Updated 3 years ago
- ☆69Updated 5 years ago
- Homie based bridge between MQTT and RFlink module☆22Updated 5 years ago
- An ESP8266 WiFi accessible serial port☆45Updated 9 years ago
- Sonoff IR remote controll extension☆57Updated 8 years ago
- MQTT Support for RFLink Gateway (http://www.nemcon.nl/blog2) project☆36Updated last year
- MiniESP for ESP01 and modules with few pins, enables GPIO 1/3 disables Serial output.☆29Updated 8 years ago
- ESP8266 / H801 RGB controller using MQTT and WiFi onboarding☆30Updated last month
- Melvanimate☆60Updated 7 years ago
- Using atmega AVR (Arduino UNO, Pollin NETIO) to log Energy Cost 3000 and TFA Dostmann temerature and humidity wireless messages☆61Updated 9 years ago
- RFM69 gateway and controller for ESP8266☆45Updated 8 years ago
- ☆24Updated 8 years ago
- Zigbee light switch with dim support base on chip cc2530☆92Updated 4 years ago
- Some nodemcu based to run sonoff wifi enabled plugs through MQTT☆46Updated 5 years ago
- An M-bus master that poll a meter and logs data to an MQTT server☆51Updated 8 years ago
- Provide ESP32 with Web, MQTT and OTA firmware using Arduino IDE or PlatformIO☆71Updated 7 years ago
- Plugin ideas, concepts, user contributed, etc☆190Updated last year
- RFLink for ESP, with MQTT client☆72Updated 2 years ago
- Code to wake up ESP8266 using external interrupt and send a MQTT message and turn itself off after external signal has vanished.☆27Updated 6 years ago
- Plugin ideas, concepts, user contributed, etc☆17Updated 5 years ago
- 1CH MQTT WiFi Relay/Thermostat Board☆31Updated 2 years ago
- ESP8266-based smart wall switch☆133Updated 7 years ago
- ☆32Updated 6 years ago