stefan73 / BetterTeslaChargeportOpenerLinks
Improved code for Arduino that creates the 433MHz ASK signal to open the Tesla Charge Port.
☆51Updated 5 years ago
Alternatives and similar repositories for BetterTeslaChargeportOpener
Users that are interested in BetterTeslaChargeportOpener are comparing it to the libraries listed below
Sorting:
- Open the Tesla charge door with an Arduino and an ASK STX882 transmitter☆139Updated 5 years ago
- System to capture digital signaldata and transfer them to another system☆89Updated last week
- Brings EVSE WB/DIN into your WiFi☆81Updated 2 years ago
- Tasmota Fork TCS34725,PN532_i2,ccc1101 Moritz support,m5stack 4,7 epaper, bresser 868 Mhz sensors and wether stations, loadable binary …☆28Updated last week
- EV dashboard - software for small dev boards connected to the car via obd2 BLE4 or CAN bus.☆152Updated 2 months ago
- This project is for connecting to EPEver charge controllers over WiFi for viewing running stats and also allows automatic posting of them…☆74Updated last year
- Controlling Jarolift TDEF 433MHZ radio shutters via ESP8266 and CC1101 Transceiver Module in asynchronous mode☆71Updated 2 years ago
- Open Source Steuerung von LIN Bus Geräten im Caravan Bereich.☆79Updated 4 years ago
- Bresser 5-in-1/6-in-1/7-in-1 868 MHz Weather Sensor Radio Receiver for Arduino based on CC1101, SX1276/RFM95W, SX1262 or LR1121☆151Updated last week
- ESP32 digital water level bubble with a ADXL345 Accelerometer☆29Updated 4 years ago
- reading SDM72 SDM120 SDM220 SDM230 SDM630 modbus energy meters from arduino (esp8266, esp32, avr)☆258Updated last year
- Contains an Arduino project for Espressif ESP32 that will run a web server with web sockets to display data from a Victron MPPT charge co…☆28Updated 5 years ago
- ESPHome component to simulate the current clamp to control the Soyosource GTN1200 limiter☆93Updated last week
- ESP82XX based connector for EPEver Solar tracker systems, control and watch Multiple devices over webinterface and MQTT☆60Updated last month
- Code to read the VE.Direct-Protocol from serial into a value array. Uses a non-blocking read loop and does checksum verification before a…☆130Updated 4 years ago
- A very flexible ESP32 power meter / energy meter with SCT-013-0x0, ZMPT101B, ACS712 sensors☆44Updated last year
- Program to read out and display data from xiaoxiang Smart BMS over Bluetooth Low Energy☆115Updated last year
- ESPHome component to monitor and control a Xiaoxiang Battery Management System (JBD-BMS) via UART-TTL or BLE☆183Updated last week
- ESP8266 Connector to get Daly / XENES / HI-BMS / BullTron BMS Data into MQTT systems☆174Updated last month
- Python lib to talk to pylontech lithium batteries 🔋 (US2000, US3000, ...) using RS485☆80Updated 2 years ago
- Read data from victron mppt and transport to mqtt server☆42Updated 3 years ago
- Esp-HuaweiR4850-Controller Das Huawei R4850G2 Recitfier Modul ist ein 3000Watt Lade Netzteil. Es kann über Datenkommunikation gesteuert w…☆70Updated last year
- MQTT 433.92 MHz radio-frequency device gateway☆137Updated 2 years ago
- Device to measure energy and temperature☆80Updated 6 years ago
- JBD BMS Linux utility☆68Updated 4 months ago
- A node red based dashboard for most EPEver/EPSolar solar charge controllers.☆68Updated 2 years ago
- Use an ESP8266 to read live-, statistical- and status-data from an EpEver LandStar (LS1024B) via Modbus and publish using MQTT☆32Updated 6 years ago
- ESP32 bridge allowing Daly Smart BMS to be used with a Sofar inverter/charger (and others that use SMA CANBUS protocol).☆33Updated last year
- Checks the level of your cistern using an ESP8266 a with a bunch of possible distance sensors (ultrasound, ToF)☆30Updated 2 years ago
- Converts the JK-BMS RS485 data to Pylontech CAN data☆91Updated 6 months ago