Ralf9 / SIGNALDuinoLinks
☆19Updated 6 months ago
Alternatives and similar repositories for SIGNALDuino
Users that are interested in SIGNALDuino are comparing it to the libraries listed below
Sorting:
- System to capture digital signaldata and transfer them to another system☆88Updated last month
- SIGNALduino direclty on ESP8266☆15Updated 6 years ago
- M-Bus gateway with web server based on ESP8266 NodeMCU☆27Updated 5 months ago
- ☆24Updated 8 years ago
- Arduino Interface for cheap 2.4ghz RF enabled Solar Micro Inverters☆66Updated 2 years ago
- an alternative dashboard site in tile optic for espeasy☆16Updated last week
- Controlling Jarolift TDEF 433MHZ radio shutters via ESP8266 and CC1101 Transceiver Module in asynchronous mode☆71Updated 2 years ago
- Bresser 5-in-1/6-in-1/7-in-1 868 MHz Weather Sensor Radio Receiver for Arduino based on CC1101, SX1276/RFM95W, SX1262 or LR1121☆150Updated last week
- With this tool, you can register entries of the CC1101 during operation read and change. You can switch to send or receive. Set the trans…☆44Updated 4 years ago
- Counterpart of SIGNALDuino, it's the code for FHEM to work with the data received from the uC☆47Updated last week
- ESP82XX based connector for EPEver Solar tracker systems, control and watch Multiple devices over webinterface and MQTT☆60Updated last month
- ☆16Updated 6 years ago
- Code to read the VE.Direct-Protocol from serial into a value array. Uses a non-blocking read loop and does checksum verification before a…☆130Updated 4 years ago
- ATtiny85 based LoRa atmospheric sensor board with BME280☆28Updated 6 years ago
- Alternative firmware for ESP8266 with easy configuration using webUI, OTA updates, automation using timers or rules, expandability and en…☆117Updated this week
- Loading EZSP (EmberZNet Serial Protocol) on IKEA TRÅDFRI ICC-A-1 Modul☆51Updated 2 years ago
- Easy-ESP8266-GPS-NTP-Server☆15Updated last year
- ESP32 driver library for TI CC1100 Low-Power Sub-1 GHz RF Transceiver☆77Updated 6 years ago
- ESPiLight - pilight 433.92 MHz protocols library for Arduino☆119Updated 2 years ago
- This code catches I2C communication by running on an ESP32 board that are connected to I2C BUS lines as a passive listener.☆46Updated 2 years ago
- Tasmota unofficial firmware builds. Install via Tasmota WebInstaller☆110Updated last week
- Project to sync analog clocks to a few milliseconds.☆40Updated 2 years ago
- ESP8266 Arduino CC1101 example☆34Updated 7 years ago
- A library that provides tools to simplify MQTT discovery implementation for Home Assistant to your device.☆48Updated last year
- A very flexible ESP32 power meter / energy meter with SCT-013-0x0, ZMPT101B, ACS712 sensors☆44Updated last year
- Burn HM-10 (CC2541) and Zigbee (CC2530 CC2531) firmware using NodeMCU board.☆44Updated 4 years ago
- ESPHome component to simulate the current clamp to control the Soyosource GTN1200 limiter☆93Updated 2 months ago
- Read data from victron mppt and transport to mqtt server☆42Updated 3 years ago
- ESPHome component to monitor and control some Atorch meters via bluetooth☆83Updated last month
- Hardware battery safety controller (BSC)☆29Updated last year