stuartpittaway / WebastoWBUSInterfaceLinks
Hardware circuit diagram for interfacing to the Webasto WBUS interface from a PC/Arduino
☆24Updated 5 years ago
Alternatives and similar repositories for WebastoWBUSInterface
Users that are interested in WebastoWBUSInterface are comparing it to the libraries listed below
Sorting:
- Arduino software for controlling Webasto ThermoTop heaters over its custom WBUS protocol☆27Updated 9 years ago
- Arduino project to control webasto heater via W-bus☆51Updated 7 years ago
- Example code to communicate with Huawei R4850G2 Power Supply via CAN☆76Updated last year
- Emulación del protocolo CANBUS de Pylontech, para comunicación con inversores fotovoltaicos, usando un ESP32☆13Updated 2 months ago
- An Arduino M0 based controller for Webasto C/E Diesel Water Heaters☆61Updated 2 weeks ago
- Arduino library for communicating with Daly BMSs over UART☆113Updated 2 years ago
- ESP8266 based WiFi interface for Voltronic Axpert MppSolar PIP inverters☆31Updated 3 years ago
- ESP32 based CAN development board☆179Updated 3 years ago
- Program to read out and display data from xiaoxiang Smart BMS over Bluetooth Low Energy☆117Updated last year
- ☆30Updated 3 years ago
- Copy of SF hosted libwbus (not ours - for safekeeping!)☆19Updated 9 years ago
- diyBMS v4 code for the ESP32 and new controller hardware☆218Updated last month
- Software for diyBMS v4☆152Updated last year
- The Valden Heat Pump controller is a platform to precisely control heat pumps☆149Updated 4 years ago
- Library for working with JBD BMS☆75Updated last year
- JK BMS to PYLON CANBUS Protocol converter☆40Updated 3 years ago
- Converts the JK-BMS RS485 data to Pylontech CAN data☆97Updated 8 months ago
- Code to read the VE.Direct-Protocol from serial into a value array. Uses a non-blocking read loop and does checksum verification before a…☆131Updated 4 years ago
- reverse-engineered schematics and interface software☆94Updated last year
- A linux software to control ZTE Tech EBC A-series battery testers and electronic loads☆30Updated 2 years ago
- Lightweight arduino library to read basic data using the VE.Direct protocol from Victron Energy☆97Updated 2 years ago
- Information gathered on the Uni-T UT210E multimeter.☆170Updated 2 years ago
- JBD BMS Linux utility☆68Updated 6 months ago
- To measure battery voltage, engine RPM, fuel level and exhaust teperature with an ESP32 and send it to a NMEA 2000 network.☆64Updated 3 years ago
- Decode tire pressure monitoring system TPMS BLE 433MHz CC1101 ESP8266 ESP32☆106Updated 3 years ago
- SimpBMS Documentation☆90Updated 3 years ago
- ☆143Updated 2 months ago
- RD6006 Python module☆106Updated last year
- Just the Arduino Library for Overkill Solar BMSs☆37Updated 3 years ago
- Software, hardware and protocol information for the Eltek Flatpack2.☆52Updated 6 years ago