atc1441 / NETSGPClient
Arduino Interface for cheap 2.4ghz RF enabled Solar Micro Inverters
☆63Updated last year
Alternatives and similar repositories for NETSGPClient:
Users that are interested in NETSGPClient are comparing it to the libraries listed below
- Extend the possibilities of cheap digital power supplies with a WiFi module☆58Updated 11 months ago
- Contains an Arduino project for Espressif ESP32 that will run a web server with web sockets to display data from a Victron MPPT charge co…☆26Updated 4 years ago
- Read data from victron mppt and transport to mqtt server☆41Updated 2 years ago
- ☆29Updated 2 years ago
- M-Bus gateway with web server based on ESP8266 NodeMCU☆25Updated 5 months ago
- JBD BMS Linux utility☆60Updated 10 months ago
- Add Home Assistant support to your RDTech power supply☆43Updated this week
- A very flexible ESP32 power meter / energy meter with SCT-013-0x0, ZMPT101B, ACS712 sensors☆43Updated last year
- ☆42Updated last year
- ☆17Updated this week
- This project is for connecting to EPEver charge controllers over WiFi for viewing running stats and also allows automatic posting of them…☆71Updated 7 months ago
- Program for reading data from a Xiaoxiang smart BMS and printing to an OLED display☆20Updated 4 years ago
- ☆15Updated 7 years ago
- Read and Write Library for Overkill Solar BMSs☆16Updated 2 years ago
- ☆43Updated last year
- ☆62Updated 5 years ago
- Microcontroller program to connect to soyosource grid tie inverter RS485 limiter connection and provide it with a demand signal based on …☆14Updated 3 years ago
- Hardware circuit diagram for interfacing to the Webasto WBUS interface from a PC/Arduino☆23Updated 5 years ago
- An ATTiny version of Julian Iletts PWM5 Solar Charge Controller☆49Updated 3 years ago
- Code to read the VE.Direct-Protocol from serial into a value array. Uses a non-blocking read loop and does checksum verification before a…☆126Updated 3 years ago
- PCB to connect a TTL reader either to an FTDI or ESP12-E/F (WiFi)☆24Updated last year
- ESPHome component to emulate a SMA/Victron compatible BMS via CAN bus☆14Updated last month
- Arduino project to control webasto heater via W-bus☆42Updated 6 years ago
- ☆42Updated 3 years ago
- Open-Source firmware for the ZPB30A1 electronic load (WIP)☆50Updated 6 years ago
- Arduino library for communicating with Daly BMSs over UART☆101Updated last year
- ESP32 bridge allowing Daly Smart BMS to be used with a Sofar inverter/charger (and others that use SMA CANBUS protocol).☆32Updated last year
- Interface layer for Daly Smart BMS☆20Updated 3 years ago
- Hardware battery safety controller (BSC)☆26Updated 11 months ago
- ☆42Updated 3 years ago