speeduino / SpeedyLoaderLinks
Speeduino universal firmware loader
☆53Updated 8 months ago
Alternatives and similar repositories for SpeedyLoader
Users that are interested in SpeedyLoader are comparing it to the libraries listed below
Sorting:
- Official Speeduino hardware designs☆235Updated last year
- ☆152Updated last month
- EMS boards powered by Speeduino☆96Updated 2 months ago
- An OLED gauge for the Speeduino ECU. Uses UART (secondary serial) for communication.☆39Updated 2 years ago
- This is an open HW project of Electronic Throttle Controller also known as Drive By Wire.☆52Updated 9 months ago
- Official and user contributed base tunes for Speeduino installations☆41Updated 9 months ago
- Speeduino compatible m5x PnP PCBs☆131Updated 2 months ago
- Speeduino compatible engine control unit (ECU) based around black STM32F407VET6 board.☆51Updated last year
- Zero Motorcycles alternative dashboard using a tft and the canbus and an Adafruit Esp32☆15Updated 3 years ago
- ☆19Updated 6 years ago
- EMS boards powered by Speeduino☆12Updated 4 months ago
- A library of kicad symbols and footprints for parts used across the Speeduino boards☆20Updated last year
- STM32 based Arduino Mega replacement for speeduino☆112Updated 2 months ago
- Standalone ECU designed for Speeduino and RusEFI firmware.☆51Updated last year
- This is a LCD based speeduino display that polls data over Serial3☆20Updated 5 years ago
- ☆11Updated 9 months ago
- blitzBOX - low-cost and mini-sized ECU for speeduino firmware (45 x 58 mm)☆53Updated 11 months ago
- Hardware - dingoPDM is an open source, affordable automotive PDM (Power Distribution Module). Pre-assembled and tested units are availabl…☆94Updated 3 weeks ago
- Speeduino - Arduino based engine management☆17Updated 2 months ago
- A dash project for tunerstudio based on RASPBIAN☆30Updated 10 months ago
- rusEFI open source lowcost CAN-bus dashboard☆19Updated last month
- ☆64Updated 2 weeks ago
- ECU designed for Speeduino firmware☆35Updated 5 years ago
- Wideband Lambda Controller with Bosch CJ125☆43Updated last year
- Standalone ECU designed for Speeduino firmware☆42Updated 5 years ago
- ☆14Updated 3 years ago
- Hardware - CAN enabled small input / output expansion board. Switch panels, steering wheel buttons/knobs, etc.☆45Updated 3 weeks ago
- An Arduino sketch for controlling a Bosch LSU 4.9 Wideband Lambda sensor with minimal parts☆85Updated 12 years ago
- 8Ch EGT sensor board to be used with aftermarket ECUs☆34Updated last year
- Please find my custom Speeduino based ECU.☆19Updated 5 years ago