richardJG / APRemoteLinks
Web based autopilot control using ESP32 and Seatalk1
☆10Updated 4 years ago
Alternatives and similar repositories for APRemote
Users that are interested in APRemote are comparing it to the libraries listed below
Sorting:
- This repository shows how to build a NMEA2000 WiFi Gateway with voltage and temperature alarms.☆86Updated 3 years ago
- An Actisense NGT-1 compatible NMEA 2000 USB gateway for the SH-ESP32☆32Updated last year
- ☆12Updated last year
- To measure battery voltage, engine RPM, fuel level and exhaust teperature with an ESP32 and send it to a NMEA 2000 network.☆64Updated 3 years ago
- ☆30Updated 3 years ago
- Universal Signal K sensor framework for the ESP32 platform☆183Updated 2 months ago
- nmea2000 gateway with ESP32☆21Updated last week
- Examples of using the ULP Co-Processor of the ESP32 with simple pulse counting, which I extended for also saving the shortest pulse.☆28Updated 3 years ago
- Code to read the VE.Direct-Protocol from serial into a value array. Uses a non-blocking read loop and does checksum verification before a…☆130Updated 4 years ago
- nmea2000 gateway with ESP32☆85Updated last week
- TTGO-T-Beam Arduino Car Tracker - ESP32 + LoRa + GPS + GSM (optional)☆186Updated last year
- An arduino sketch to connect the EPSolar/EPEver Tracer A/B Series (RS-485 Modbus) to an ESP8266 and monitor using the Blynk mobile app - …☆60Updated 4 years ago
- A very flexible ESP32 power meter / energy meter with SCT-013-0x0, ZMPT101B, ACS712 sensors☆44Updated last year
- This repository shows how to build a Seatalk Autopilot Remote Control device based on an Arduino ProMicro and a simple 433 MHz KeyFob.☆67Updated 3 months ago
- Program to read out and display data from xiaoxiang Smart BMS over Bluetooth Low Energy☆115Updated last year
- M5Stack Tough (ESP-32) Sailing Instruments Display and Autopilot Control☆115Updated 7 months ago
- ☆161Updated last year
- Lightweight arduino library to read basic data using the VE.Direct protocol from Victron Energy☆95Updated 2 years ago
- Open hardware digital switching for boats☆24Updated 11 months ago
- Simple library for Arduino (ESP32) to control a Chinese diesel heater through 433 MHz RF☆98Updated 5 years ago
- SensESP setup for monitoring 3 boat batteries☆21Updated 4 months ago
- Library for working with JBD BMS☆75Updated last year
- An Arduino library for the Hi-Link LD2410 24Ghz FMCW radar sensor.☆202Updated last month
- Code to make experiment on TTN Mapper with GPS and TTGO☆58Updated 5 years ago
- Reset U-blox NEO GPS devices on TTGO T-beam T22- V1.0 and 1.1 back to factory settings☆67Updated 3 years ago
- ☆35Updated last year
- Electricity monitoring library - install in Arduino IDE's libraries folder then restart the IDE☆73Updated last year
- A node red based dashboard for most EPEver/EPSolar solar charge controllers.☆68Updated 2 years ago
- Sailor Hat for ESP32 hardware☆47Updated 11 months ago
- Begleitcode für das Buch☆47Updated 7 months ago