pfalcon / blutunodeLinks
Autonomous wireless sensor/actuator node using bluetooth modules based on CSR BlueCore chipset. See wiki for more info.
☆154Updated 7 years ago
Alternatives and similar repositories for blutunode
Users that are interested in blutunode are comparing it to the libraries listed below
Sorting:
- Raspberry PI bare metal☆48Updated 12 years ago
- A clone of the i2c-tiny-usb based upon STM32 and libopencm3☆143Updated 2 years ago
- Implementation of new methods of communicating with Csr BlueCore chips using the BlueLab 4.1 framework, mainly for those without a functi…☆61Updated 7 years ago
- Reverse engineered reimplementation of the CSR USB<>SPI converter device on a Stellaris Launchpad. Will work with the original CSR driver…☆58Updated 12 years ago
- library for ones of the worst of chinese nRF24l01+ "alternatives"☆71Updated last year
- A Qi wireless power receiver using attiny13☆58Updated 6 years ago
- A stable ESP8266 port of OpenOCD☆55Updated 6 years ago
- The JTAGduino project has the goal of using Arduino as a JTAG interface.☆115Updated 11 years ago
- FX2 EZ USB eeprom reader/writer for libusb☆30Updated 2 years ago
- ESP8266 based Raspberry Pi WiFi module☆25Updated 10 years ago
- Yes, your Arduino can replace an expensive JTAG cable!☆158Updated 12 years ago
- An inexpensive Open Source blackmagic probe compatible SWD debugger designed to be used with ARM GDB.☆35Updated 6 years ago
- Implement Silabs C2 flash protocol via ARM and AVR☆35Updated 11 years ago
- Access Dallas 1-Wire bus on your PC via low-cost USB to UART bridge.☆166Updated 8 years ago
- ESP8266 firmware that implements the SWIM protocol for debug access / flashing of STM8 devices☆99Updated last year
- BASIC interpreter for CC2540 and CC2541 Bluetooth LE chips☆98Updated 7 years ago
- Drive an old laptop display from an 8-bit AVR microcontroller☆20Updated 10 years ago
- ST-Link dumper firmware☆54Updated last year
- ESP8266 as wireless JTAG Programmer☆173Updated 7 years ago
- JTAG Versaloon firmware for the STM32 Bluepill board☆143Updated 3 years ago
- OLS is a $50 32 channel Logic Analyzer☆121Updated 14 years ago
- This is the fast avr programmer for AVR MCUs based on cheap stm32f103c8t6 board with usb-to-serial support.☆104Updated 5 months ago
- ☆23Updated 3 years ago
- STK500 compatible UPDI programmer firmware for Arduino☆28Updated 7 years ago
- An implementation of the SWD protocol using the Bus Pirate☆90Updated 8 years ago
- Utility for reading EnergyTrace data from TI debug hardware☆38Updated 4 years ago
- Set the voltage of a Quick Charge 2.0 source via the Arduino.☆68Updated 8 years ago
- PL2303HX Userspace GPIO control tool☆36Updated 5 years ago
- ATMega16U2 firmare - faster than arduino-usbserial☆23Updated 10 years ago
- nRF24L01+ bootloader for avr and other mcus☆108Updated last year