diodep / ch55x_dualserialLinks
CH552 Dual USB to Serial Bridge.
☆79Updated last year
Alternatives and similar repositories for ch55x_dualserial
Users that are interested in ch55x_dualserial are comparing it to the libraries listed below
Sorting:
- USB-Blaster instance on CH55x MCU.☆53Updated 6 years ago
- Open-source CH55x flashing tool, SDK....☆152Updated 3 years ago
- USB-JTAG Adapter Using CH552☆69Updated 3 years ago
- CH55x USB to JTAG bridge☆141Updated 9 months ago
- An Open-Source CMSIS-DAP Debug Probe based on DAPLink and USB bus convert and it can realize USB convert to serial interface based in CH5…☆95Updated last year
- Opensource embedded controller firmware for sipeed boards.☆44Updated 6 years ago
- ☆26Updated 6 years ago
- a cheap CMSIS-DAP debugger by an WCH chip named CH549F☆48Updated 4 years ago
- L1 R1：WCH 24MHz MCS-51 USB MCU (CH552T/CH552P/CH552E/CH552G/CH551G)☆60Updated 2 years ago
- A minimum development board for CH32V203G6.☆45Updated 3 years ago
- Single-chip solution for Hi-speed USB2.0(480Mbps) JTAG/SPI Debugger based on RISC-V MCU CH32V30x/CH32V20x☆119Updated 2 years ago
- A low cost FPGA/CPLD dev-board based on AG1280Q48.☆71Updated 5 months ago
- Use gpio to emulate usb low-speed on stm32f030f4p6.Use internal rc instead of crystal.☆35Updated 8 years ago
- An USB to Serial bridge based on CH55x series MCU.☆24Updated last year
- ☆36Updated 6 months ago
- 8051 microcontroller☆41Updated 8 years ago
- Longan RV32 Boards Document☆47Updated 5 years ago
- ICN6211 Configurator☆42Updated 5 years ago
- An open sourced python tool for flashing WCH CH55x series USB microcontroller with bootloader v2.30, v2.31 & v2.40.☆169Updated last year
- USB Composite Device Demo (Keyboard, Custom HID and Massive Storage) using CH55x☆122Updated 5 years ago
- L4：Cortex A5 GSM SoC RDA8810☆25Updated 6 years ago
- Low-speed USB implemented on STM8 microcontrollers☆90Updated 8 years ago
- OpenOCD source code for CH32V series MCUs released by Mounriver IDE☆55Updated 3 years ago
- Port of https://github.com/eleqian/WiDSO/tree/master/MCU/USB-Blaster to GCC and "traditional" STM32F103C8T6 Bluepill board.☆43Updated 6 years ago
- The whole NFC solution (source code and schematic&layout) based on WCH chips☆46Updated 2 years ago
- ☆79Updated 6 years ago
- F1C200S PCB and SCH☆73Updated 4 years ago
- ☆35Updated 11 months ago
- This is the OpenOCD source code modified to support WCHlink and CH32Vxxx MCUs, received from MounRiver after my GPL request, and publishe…☆18Updated 3 years ago
- M1s_BL808_example☆69Updated 2 years ago