cnlohr / rtgz-tinf-utilLinks
raw zlib data utility + tinfl single-file-header, geared for embedded environments
☆14Updated 11 months ago
Alternatives and similar repositories for rtgz-tinf-util
Users that are interested in rtgz-tinf-util are comparing it to the libraries listed below
Sorting:
- Arduino library that supports CF Cards and PATA drives☆36Updated 4 years ago
- Test of a RP2040 PMOD attached to a LiteX SoC.☆25Updated 2 years ago
- sn76489an compatible Verilog core, with emphasis on FPGA implementation and Megadrive/Master System compatibility☆31Updated 5 months ago
- Converts the output from an old TMS9928A Video Display Processor to drive a small TFT panel using either an SPI or a parallel interface. …☆27Updated 2 years ago
- RP2040 MCU based PMOD☆20Updated 6 months ago
- Versatile tool to untangle wires. Made by chip researchers - for chip researchers. This means that the utility is wildly custom and incom…☆52Updated 2 months ago
- Firmware for Raspberry Pico to work as JTAG debugger using OpenOCD☆45Updated 2 months ago
- SNES SPC music player for Tang Nano 20k☆20Updated last year
- DVI for HSTX☆14Updated 2 months ago
- Flashing Pano Logic thin clients without a programmer☆40Updated 3 years ago
- Low-area DVI experiment for iCE40 UP5k and HX1k FPGAs☆31Updated 3 years ago
- My notes on various programming languages and CS concepts☆16Updated 2 years ago
- Collection of Raspberry Pi Pico board adapters for use with Pico-DirtyJTAG☆13Updated last year
- CH32V UF2 bootloader☆47Updated 9 months ago
- x86 emulator on Raspberry Pi Pico☆63Updated 8 months ago
- infones for pico☆78Updated 8 months ago
- An Arduino as an XSVF player to program CPLD's and FPGA's☆27Updated 3 years ago
- Drop-in replacements for metal can and half can style crystal oscillators☆41Updated 4 years ago
- A dual-socket USB host PMOD module.☆12Updated 2 months ago
- Use the ch32v003 as a usb pd controller☆39Updated 11 months ago
- ☆22Updated 3 years ago
- Using the ch32v003 as a temperature sensor☆18Updated last year
- 2-layer FPGA development board with ZYNQ 7010/7020 400-pin BGA.☆19Updated 8 months ago
- A port of Quake (supporting both Shareware and Full) to Silicon Labs EFR32MG24/MGM240 devices, using only 276 kB of RAM!☆33Updated 7 months ago
- ☆12Updated 7 months ago
- Main_MiSTeX binary☆30Updated last year
- Firmware and software support for the pico-ice board☆58Updated 2 weeks ago
- Raspberry Pi Pico NTSC 8-bit Composite Video output using Resistor R2R DAC, interlaced at 640x480, with slideshow on second core.☆57Updated 2 years ago
- Documentation of an effort to reverse engineer a Cisco 2501 router, with the end goal to run my own code on it (in particular FreeRTOS)☆25Updated last year
- community projects that can be used with the ULX3S FPGA ESP32 board☆16Updated 6 months ago