cbradburne / Pan-Tilt-Mount
A stepper motor driven, 3D printed and Arduino controlled pan/tilt mount.
☆12Updated 2 years ago
Alternatives and similar repositories for Pan-Tilt-Mount:
Users that are interested in Pan-Tilt-Mount are comparing it to the libraries listed below
- 3D Printed 3 Axis Camera Slider, remote controlled via Bluetooth☆30Updated 3 years ago
- My DIY 3 Axis Camera Slider Project☆24Updated 3 years ago
- A Pendant for FluidNC CNC Firmware☆51Updated 3 weeks ago
- DIY WiFi Enabled Camera Slider using ESP32☆117Updated 2 months ago
- Arduino OLED Rlelay and DS18B20 to control heater element of a 3D printing Filament dryer.☆37Updated 4 years ago
- ☆25Updated 4 years ago
- ☆15Updated 2 years ago
- Files for the 7 segment clock☆14Updated 6 years ago
- ☆40Updated last year
- ☆16Updated last year
- Professional level DIY Camera Motion Control System☆96Updated last month
- Need to transport a pencil across your desk or perhaps a stack of sticky notes? Never fear the MiniDump is here.☆17Updated last year
- Alternate firmware for Orbion mouse CAD☆16Updated 2 months ago
- ☆40Updated last year
- The closed-loop drive is to feedback the rotation angle of the stepping motor to the control panel, compare the distance that needs to be…☆21Updated 2 years ago
- RepRapFirmware configuration and macros to drive the Enraged Rabbit Carrot Feeder☆40Updated last year
- Pendants for controlling FluidNC CNC firmware☆40Updated last month
- Controlling LEDs from Klipper using LED Control from jackw01. This repository contains the needed files and an installation script.☆37Updated 2 years ago
- DIY WiFi Filament dryer☆160Updated last year
- MarlinBuilder☆71Updated 3 weeks ago
- A port of the BigTreetech Touchscreen Firmware for Marlin 3d printer boards- Added support for Makerbase MKS TFT28/MKSTFT32, should not b…☆34Updated 5 years ago
- This is a combined joystick and touch panel display suitable for use with common CAD programs.☆23Updated last year
- ☆17Updated 2 years ago
- to streamline the install or upgrade of KLIPPER & DWC2 front-end for it. With these 2 together no need to use octoprint. I run mine on or…☆55Updated 4 years ago
- Combining 3d printed and metal parts to build an open source motorized dslr slider.☆15Updated 2 years ago
- A CNC Pendant on ESP32 board, with LCD, WiFi and SD card☆76Updated 11 months ago
- A set of node-red nodes to interface with the Moonraker API for Klipper☆18Updated last year
- ESP32 DIY Digital Readout☆95Updated 5 years ago
- Anycubic Chiron with Mainsail, Klipper, Raspberry Pi and TMC2209☆19Updated 2 years ago
- This is my project to enable serial (UART) connected BigTreeTech-TouchScreens with Klipper by emulating anything it needs with macros.☆30Updated 4 months ago