Xevel / NXV11
Hacking of the Neato XV-11 lidar
☆84Updated 4 years ago
Alternatives and similar repositories for NXV11
Users that are interested in NXV11 are comparing it to the libraries listed below
Sorting:
- Arduino code for controlling the Neato XV Lidar☆131Updated 3 years ago
- Neato XV-11 LIDAR connected to an STM32F429IDISCOVERY board for 360-degree range scanning and measurement☆41Updated 10 years ago
- A 3D printed raspberry pi ROS robot☆24Updated 9 years ago
- This is the Arduino version of the code for my balancing robot/segway☆75Updated 12 years ago
- raspilot hardware☆18Updated 9 years ago
- Eddie the Balance Bot☆62Updated 8 years ago
- roslaunch for xv11 neato lidar for using hector mapping without odometery☆13Updated 8 years ago
- Embedded firmware and web user interface for self balancing telepresence robot☆31Updated 7 years ago
- ☆27Updated 7 years ago
- ☆30Updated 7 years ago
- ☆51Updated 8 years ago
- Smaller PocketBeagle version of the BBBmini flight controller.☆85Updated 6 years ago
- Git repository for the Balanduino balancing robot☆133Updated 3 years ago
- Arduino and Processing code for an A3080 or ADNS3080 optical flow sensor☆45Updated 2 years ago
- An autopilot for Linux-based computers based on the BeagleBone (Black)☆109Updated 8 years ago
- ☆60Updated 8 years ago
- OpenServo Version 4☆20Updated 12 years ago
- UAV autopilot☆41Updated 6 years ago
- APM Plane, APM Copter, APM Rover source☆36Updated 8 years ago
- Arduino Library for interaction and learning about LIDAR-Lite v2 "Blue Label"☆67Updated 6 years ago
- Monster Moto Shield available from SparkFun Electronics.☆30Updated 4 years ago
- ☆10Updated 5 years ago
- ☆46Updated 7 years ago
- Arduino/Processing sketch for GY80 9DOF AHRS☆22Updated 12 years ago
- ☆28Updated 8 years ago
- Controller board for wheeled robots, based on the ESP8266 with three DC motors drivers, one-cell LiPo battery charger and Wifi connectivi…☆15Updated 9 years ago
- Arduino driver for PMW3901 optical flow sensor☆62Updated 2 years ago
- ☆35Updated 6 years ago
- A sample Arduino sketch to drive one motor using the self balancing scooter motor controller - for 3.3V Arduino ONLY!☆38Updated 8 years ago
- Modification of the tgy firmware to support I2C communication for the BlueESC.☆22Updated 6 years ago