AvaotaSBC / AvaotaHyperCardLinks
AvaotaHyperCard is a TF card multiplexer enabling seamless switching between native TF card and USB disk modes via a button.
☆28Updated last year
Alternatives and similar repositories for AvaotaHyperCard
Users that are interested in AvaotaHyperCard are comparing it to the libraries listed below
Sorting:
- Opensource embedded controller firmware for sipeed boards.☆44Updated 6 years ago
- CH552 Dual USB to Serial Bridge.☆78Updated last year
- Run Linux on MCUs such as ESP32C3 with RISC-V emulator☆126Updated last year
- OpenOCD source code for CH32V series MCUs released by Mounriver IDE☆55Updated 3 years ago
- SDK sch&layout reference design and datasheet documention☆69Updated last year
- USB2Sniffer: High Speed USB 2.0 capture (for LambdaConcept USB2Sniffer hardware)☆58Updated 5 years ago
- USB-Blaster instance on CH55x MCU.☆54Updated 6 years ago
- ☆129Updated 2 years ago
- M1s_BL808_Linux_SDK☆33Updated 3 years ago
- 8051 microcontroller☆40Updated 8 years ago
- forked from https://github.com/riscv/riscv-openocd.git,and add falsh support for LicheeTang☆24Updated 4 years ago
- A minimum development board for CH32V203G6.☆45Updated 3 years ago
- ☆27Updated 7 years ago
- Document for Tang Nano FPGA board☆58Updated 5 years ago
- AGM bitstream utilities and decoded files from Supra☆47Updated 5 months ago
- Altera "USB_Blaster" clone using Teensy 3.5 microcontroller☆23Updated 5 years ago
- Single-chip solution for Hi-speed USB2.0(480Mbps) JTAG/SPI Debugger based on RISC-V MCU CH32V30x/CH32V20x☆121Updated 2 years ago
- HydraUSB3 (WCH CH569) open source test firmware / examples / libraries to experiment with streaming / high-speed protocols (USB2 HS, USB3…☆89Updated 2 years ago
- BTstack Port for BL618☆12Updated 8 months ago
- A low-resource graphics library for MCUs with anti-aliased font rendering☆41Updated last week
- M1s_BL808_example☆70Updated 2 years ago
- ☆25Updated 4 years ago
- The whole NFC solution (source code and schematic&layout) based on WCH chips☆48Updated 2 years ago
- CH55x USB to JTAG bridge☆141Updated 10 months ago
- ☆104Updated 4 months ago
- Load bitstream to AG1K series FPGA using CH552☆12Updated 4 years ago
- ESP8266 Xilinx Virtual Cable - wifi JTAG☆39Updated 4 years ago
- Yuzuki Rosetta is a low-cost Linux development board based on the R328-S3. Dual-core A7, 128MB RAM, NAND Flash, WI-FI&BT. Raspberry Pi Ze…☆31Updated 2 years ago
- M1s(BL808)SDK☆59Updated 2 years ago
- RV-Debugger-BL702 Project, an opensource debugger implement☆214Updated last year