vedderb / SparkSwitch
Active precharce circuit with optional switch input
☆49Updated 9 years ago
Alternatives and similar repositories for SparkSwitch:
Users that are interested in SparkSwitch are comparing it to the libraries listed below
- BLE-UART bridge for the VESC with packet handling and VESC Tool compatibility☆58Updated 7 months ago
- personal improvements/changes to the vedder antispark switch☆65Updated 6 years ago
- BLDC Motor Controller based on the VESC 4.12 hardware☆74Updated 4 years ago
- A200S ESC - Based upon the VESC®*-Project☆51Updated 6 years ago
- Arduino based remote for VESC with nRF24☆44Updated 7 years ago
- High voltage high power ESC using VESC logic☆52Updated 6 years ago
- A bootloader for my custom motor controller. Read more at http://vedder.se/2015/01/vesc-open-source-esc/☆70Updated 3 years ago
- Arduino library to interface with the VESC bldc over UART.☆142Updated 3 years ago
- This is the firmware for the VESC Wand remote control☆18Updated 2 years ago
- ☆125Updated 6 years ago
- BLE-UART bridge for the VESC with packet handling and VESC Tool compatibility.☆38Updated last year
- A project that demonstrates how to communicate between the VESC and a STM32F4 discovery board using UART☆96Updated 4 years ago
- BESC second generation☆50Updated 3 years ago
- Firmware for DAVEga, a device for electronic skateboards that displays data read from VESC based speed controllers.☆56Updated 4 years ago
- Custom PCB for nunchuks☆25Updated 9 years ago
- MESC, Molony ESC, STM32F303 based FOC+BLDC ready, HALL, Encoder, Sensorless, single sides, 2 layer, ~90A @48V☆45Updated 4 years ago
- Hardware files for OtterControl BLDC motor controller☆64Updated 5 years ago
- The source code for the VESC Express☆51Updated this week
- In this project, I want to read out telemetry data of the "VESC" speed controller by Benjamin Vedder via UART and display it on an OLED d…☆36Updated 8 years ago
- Bootloader for the VESC BMS☆20Updated 3 years ago
- Firmware for 3 Phase BLDC controller☆41Updated 5 years ago
- STM32 32-bit microcontroller based UAVCAN nodes for DIY☆78Updated 5 years ago
- A capacitor PCB for the VESC☆14Updated 9 years ago
- ☆30Updated 7 years ago
- ☆21Updated 3 years ago
- Low cost servo drive for small CNC machinery☆54Updated 8 years ago
- Inverter for brushless motors☆60Updated 6 years ago
- A minimal raspberry pi 3 or 4 image that runs VESC Tool☆29Updated 3 years ago
- ☆48Updated 7 years ago
- Battery management system for a VESC☆26Updated 5 years ago