vedderb / nrf52_vescLinks
BLE-UART bridge for the VESC with packet handling and VESC Tool compatibility.
☆38Updated last year
Alternatives and similar repositories for nrf52_vesc
Users that are interested in nrf52_vesc are comparing it to the libraries listed below
Sorting:
- This is the firmware for the VESC Wand remote control☆18Updated 2 years ago
- The source code for the VESC Express☆52Updated this week
- A minimal raspberry pi 3 or 4 image that runs VESC Tool☆29Updated 3 years ago
- BLE-UART bridge for the VESC with packet handling and VESC Tool compatibility☆59Updated 8 months ago
- Bootloader for the VESC BMS☆20Updated 3 years ago
- BESC second generation☆50Updated 4 years ago
- A200S ESC - Based upon the VESC®*-Project☆51Updated 6 years ago
- BLDC Motor Controller based on the VESC 4.12 hardware☆74Updated 5 years ago
- MESC, Molony ESC, STM32F303 based FOC+BLDC ready, HALL, Encoder, Sensorless, single sides, 2 layer, ~90A @48V☆45Updated 4 years ago
- Battery management system for a VESC☆26Updated 5 years ago
- A bootloader for my custom motor controller. Read more at http://vedder.se/2015/01/vesc-open-source-esc/☆70Updated 3 years ago
- ☆21Updated 3 years ago
- Multi-Platform, Modular, Powerful ESC☆108Updated last year
- Firmware for the DieBieMS☆53Updated 4 years ago
- High voltage high power ESC using VESC logic☆52Updated 6 years ago
- Phobia Motor Controller☆63Updated last month
- Motor control firmware implementing FOC for STM32F103☆41Updated 3 years ago
- Custom PCB design and firmware, which serve as a ESC or BLDC controller, to drive brushless BLDC motors using my own control algorithms.☆74Updated 3 years ago
- EV motor controller with space to have customizable electronics and be easy to repair and build.☆37Updated 2 years ago
- ☆30Updated 11 months ago
- A project that demonstrates how to communicate between the VESC and a STM32F4 discovery board using UART☆98Updated 4 years ago
- Hardware design for the flatmcu - an STM32G4 based BLDC / FOC motor controller.☆27Updated last year
- Open source project that uses the CANable hardware from protofusion.org☆38Updated 5 years ago
- Active precharce circuit with optional switch input☆49Updated 9 years ago
- A capacitor PCB for the VESC☆14Updated 9 years ago
- Inverter for brushless motors☆60Updated 7 years ago
- ☆125Updated 6 years ago
- Eagle schematics of inverter main board, sensor boards and gate drivers☆66Updated 2 years ago
- General purpose STM32G4-codebase that works with VESC Tool☆17Updated 4 months ago
- The DieBieMSTool can be used to configure the DieBieMS. More documentation will follow.☆35Updated 5 years ago