thinkoco / mi-lcdLinks
A multiple interface (intel 8080, 3-wire SPI, DPI RGB ) 5 inch TFT LCD capacitive touch screen which is compatible with teraisc DE-series boards
☆20Updated 4 years ago
Alternatives and similar repositories for mi-lcd
Users that are interested in mi-lcd are comparing it to the libraries listed below
Sorting:
- USB-JTAG Adapter Using CH552☆70Updated 3 years ago
- The program for USB-Blaster Chinese version on STM32 works with☆32Updated 8 years ago
- A tiny FPGA core module based on GW1NZ-LV1, CH552 and SLG46580☆26Updated 3 years ago
- CH55x USB to JTAG bridge☆137Updated 6 months ago
- A low cost FPGA/CPLD dev-board based on AG1280Q48.☆68Updated 3 months ago
- Binary blob for Anlogic USB-JTAG adapter (temporary), We should figure out much better solution next year.☆18Updated 7 years ago
- FPGA core boards / evaluation boards based on CDCTL hardware☆93Updated 4 years ago
- Simple mono FM Radio.☆48Updated 9 years ago
- The directory to save GD32VF103 DataSheets☆19Updated 4 years ago
- Communication channel from FPGA (Alterra EP4CE10) and Linux (Lichee PI Allwinner V3S)☆29Updated 5 years ago
- Single-chip solution for Hi-speed USB2.0(480Mbps) JTAG/SPI Debugger based on RISC-V MCU CH32V30x/CH32V20x☆115Updated 2 years ago
- USB-Blaster instance on CH55x MCU.☆50Updated 6 years ago
- Demo of kendryte k210 FreeRTOS SDK☆66Updated 5 years ago
- ☆78Updated 6 years ago
- CH552 Dual USB to Serial Bridge.☆78Updated last year
- An Open-Source CMSIS-DAP Debug Probe based on DAPLink and USB bus convert and it can realize USB convert to serial interface based in CH5…☆95Updated last year
- ☆30Updated 4 years ago
- An open source FPGA design for DSLogic☆163Updated 11 years ago
- Digilent JTAG clone hardware + eeprom firmware (.bin)☆67Updated 3 years ago
- Altera USB Blaster porting to Artery AT32F425 and WCH CH32V203.☆24Updated 3 months ago
- Allwinner V3s Documentation☆58Updated 4 years ago
- ☆27Updated 6 years ago
- Opensource embedded controller firmware for sipeed boards.☆14Updated 6 years ago
- Opensource embedded controller firmware for sipeed boards.☆42Updated 6 years ago
- simple DSO over Wi-Fi☆112Updated 8 years ago
- ☆11Updated 3 years ago
- fft - kendryte k210 / Sipeed M1 dock☆33Updated 6 years ago
- Use gpio to emulate usb low-speed on stm32f030f4p6.Use internal rc instead of crystal.☆35Updated 8 years ago
- Tang-Hex-BSP: BSP for ZYNQ 7020 based FPGA Board Tang-Hex☆13Updated 6 years ago
- ☆19Updated 5 years ago