Alternatives and similar repositories for evDash

Users that are interested in evDash are comparing it to the libraries listed below

• kolins-cz / Smart-BMS-Bluetooth-ESP32
  Program to read out and display data from xiaoxiang Smart BMS over Bluetooth Low Energy
  ☆117Updated last year
• Xinyuan-LilyGO / T-CAN485
  ☆143Updated last month
• syssi / esphome-jbd-bms
  ESPHome component to monitor and control a Xiaoxiang Battery Management System (JBD-BMS) via UART-TTL or BLE
  ☆192Updated last week
• softwarecrash / Daly2MQTT
  ESP8266 Connector to get Daly / XENES / HI-BMS / BullTron BMS Data into MQTT systems
  ☆176Updated 3 months ago
• meatpiHQ / wican-fw
  ☆525Updated last week
• mkaiser / ESP32-CAN
  PCB with ESP32 and CAN bus. For controlling CAN-devices like heatpumps via ESPHome
  ☆33Updated 2 years ago
• ra6070 / BLE-TPMS
  ESP32 BLE Tire Pressure Management System
  ☆113Updated 5 years ago
• akos-sereg / esp32-obd2
  Experimental - OBD2 to feed custom device via bluetooth
  ☆93Updated last year
• JejuSoul / OBD-PIDs-for-HKMC-EVs
  Setting up Torque Pro to show OBD data on Hyundai / Kia Electric Vehicles
  ☆258Updated 4 years ago
• botaneta / JKbms_Emu_Pylon
  Emulación del protocolo CANBUS de Pylontech, para comunicación con inversores fotovoltaicos, usando un ESP32
  ☆13Updated 2 months ago
• physee / Victron.Arduino-ESP8266
  Code to read the VE.Direct-Protocol from serial into a value array. Uses a non-blocking read loop and does checksum verification before a…
  ☆130Updated 4 years ago
• loopyengineeringco / Daly2Sofar
  ESP32 bridge allowing Daly Smart BMS to be used with a Sofar inverter/charger (and others that use SMA CANBUS protocol).
  ☆33Updated 2 years ago
• NismoBoy34 / Esp32LeafInverterBridge
  esp32 Based can-bridge with webserver
  ☆18Updated last year
• SimonRafferty / Webasto-Heater---Replacement-Controller
  An Arduino M0 based controller for Webasto C/E Diesel Water Heaters
  ☆61Updated last week
• muccc / WomoLIN
  Open Source Steuerung von LIN Bus Geräten im Caravan Bereich.
  ☆81Updated 4 years ago
• MagnusThome / RejsaCAN-ESP32
  ESP32 and ESP32-S3 board with CAN interface, runs on 12V power (with auto shutdown)
  ☆685Updated 3 weeks ago
• spot2000 / Volkswagen-MEB-EV-CAN-parameters
  ☆37Updated last year
• tgalarneau / bms
  JBD BMS and Thornwave bluetooth data monitoring
  ☆48Updated 3 years ago
• sshoecraft / jbdtool
  JBD BMS Linux utility
  ☆68Updated 6 months ago
• mc0110 / inetbox2mqtt
  communicate over mqtt protocol to simulate a truma inetbox
  ☆108Updated 8 months ago
• CurtRod / SimpleEVSE-WiFi
  Brings EVSE WB/DIN into your WiFi
  ☆81Updated 2 years ago
• uhi22 / wifican
  Bridge between Wifi and CAN. Minimal variant of the ESP32RET. Using ESP32s3
  ☆35Updated last year
• voltlog / CanLite
  ESP32 based CAN development board
  ☆179Updated 3 years ago
• irekzielinski / Pylontech-Battery-Monitoring
  Adding WiFi monitoring to US2000B and US2000C batteries.
  ☆150Updated 3 years ago
• jakkik / DieselHeaterRF
  Simple library for Arduino (ESP32) to control a Chinese diesel heater through 433 MHz RF
  ☆101Updated 5 years ago
• fotherja / EV_Charger
  Arduino Uno Code for EV Charger
  ☆158Updated last year
• syssi / esphome-soyosource-gtn-virtual-meter
  ESPHome component to simulate the current clamp to control the Soyosource GTN1200 limiter
  ☆94Updated this week
• openenergymonitor / open_evse
  Firmware for OpenEnergyMonitor OpenEVSE
  ☆18Updated 3 years ago
• maxx-ukoo / jk-bms2pylontech
  JK BMS to PYLON CANBUS Protocol converter
  ☆40Updated 3 years ago
• danpeig / ESP32EnergyMonitor
  Multiple phase DIY energy consumption monitor using ESP32 and ESPHome
  ☆218Updated last month