machdyne / atioLinks
RP2040 firmware for controlling GPIO over USB CDC with AT commands
☆12Updated 8 months ago
Alternatives and similar repositories for atio
Users that are interested in atio are comparing it to the libraries listed below
Sorting:
- SPI NOR flash programmer using Blue Pill (STM32 development board)☆19Updated 7 years ago
- OpenOCD source code for CH32V series MCUs released by Mounriver IDE☆55Updated 3 years ago
- This is the OpenOCD source code modified to support WCHlink and CH32Vxxx MCUs, received from MounRiver after my GPL request, and publishe…☆18Updated 3 years ago
- Simple peripheral library for CH55x microcontrolles☆16Updated 4 years ago
- Firmware for the FX2 which emulates the FTDI serial chips (including MPSSE support).☆15Updated 7 years ago
- ☆29Updated 5 years ago
- ☆15Updated 8 months ago
- 8051 microcontroller☆40Updated 7 years ago
- ☆26Updated 6 years ago
- Firmware for Raspberry Pico to work as JTAG debugger using OpenOCD☆57Updated 5 months ago
- RP2040 Minimal hardware (PIO) Ethernet interface + LwIP TCP/IP stack driver☆34Updated last year
- An exploration into unsafely written code☆74Updated 2 years ago
- usb-jtag - Altera USB Blaster Emulation with a FX2☆72Updated 4 years ago
- a cheap CMSIS-DAP debugger by an WCH chip named CH549F☆47Updated 4 years ago
- simple and cheap 16 channel logic analyzer based on Cypress CY7C68013A development board☆36Updated 5 years ago
- Opensource embedded controller firmware for sipeed boards.☆42Updated 6 years ago
- ☆19Updated 5 years ago
- RP2040 MCU based PMOD☆20Updated 9 months ago
- Simple demo firmware for the RISC-V GD32VF103☆29Updated 4 years ago
- i2c sniffer with a Raspberry Pi Pico☆86Updated 4 years ago
- USB-Blaster instance on CH55x MCU.☆50Updated 6 years ago
- Just messing with an FPGA☆25Updated 5 years ago
- PCBs designed by Icenowy☆27Updated 3 years ago
- Simple CH347 SPI-NOR programmer☆16Updated last year
- ☆41Updated 4 years ago
- ☆35Updated last year
- Raspberry Pi hat to test Vaio P displays☆19Updated 8 months ago
- Deprecated, use 'wlink' instead. Command line tool to switch WCH-LinkE modes between DAP and RV from host.☆10Updated 9 months ago
- CH32V305 DAPLink - USB2.0 High Speed DAPLink firmware for the WCH-LinkE☆20Updated last year
- Small hobby computer based on Allwinner's F1C100S (F1C200S) processor☆23Updated 2 years ago