Alternatives and similar repositories for STN1110:

Users that are interested in STN1110 are comparing it to the libraries listed below

• ZakKemble / Car-Rev-Alarm
  DIY Car Rev Alarm and Gear Indicator
  ☆13Updated 7 years ago
• connorwm / J1850VPW
  Arduino Code (eventually library) for communicating with J1850 VPW OBD-II equipped cars.
  ☆20Updated 9 years ago
• darkspr1te / elm327_clone
  ELM327 firmware for pic18f25k80 chip from china clone OBD2 diag boxes
  ☆37Updated 7 years ago
• qnx425 / PIC18F25K80-Bootloader
  PIC Bootloader for ELM327SLCAN
  ☆22Updated 5 years ago
• darkspr1te / J2534-pic
  *on hold * Implement J2534 interface with a cheep Chinese elm327 copy (pic18f25k80)
  ☆16Updated 6 years ago
• tomaskovacik / VAGRadioRemote
  arduino library for remote controling V.A.G. radios
  ☆10Updated 3 years ago
• LegacyNsfw / 12593358
  Reverse engineering GM's powertrain control module software from my Corvette
  ☆11Updated 4 years ago
• pierremolinaro / acan
  CAN Driver for Teensy 3.1 / 3.2, 3.5 and 3.6
  ☆11Updated 9 months ago
• EstevanTH / CAN-Monitoring_ELM327
  Tool to monitor a CAN bus with an ELM327 chip, producing WebSocket + CAN-ETH outputs & pcap log
  ☆19Updated 4 years ago
• rvmiller89 / arduino_obd
  Arduino OBD-II Interface
  ☆20Updated 2 years ago
• sebi2k1 / openCanSuite
  ☆30Updated 7 years ago
• BretStateham / arduino-ecu-simulator
  Arduino ECU Simulator
  ☆19Updated 5 years ago
• McNeight / arducross
  Arduino based CAN bus reader and logger for vehicle information important to autocross racers
  ☆12Updated 10 years ago
• karlyamashita / common_libraries
  These are reusable libraries. You'll need to include the LSP.h file and remove comment for what you need.
  ☆24Updated last month
• NOELV70 / j2534-tcp
  Virtual J2534 driver over TCP/IP
  ☆14Updated 3 years ago
• x893 / BusPirateConsole
  BusPirate Console
  ☆37Updated 7 years ago
• saleae / can-analyzer
  Saleae Controller Area Network (CAN) Analyzer
  ☆19Updated last year
• fville / CANAnalyzer
  CAN bus analyzer written in python+wxPython. Works with Lawicel CANUSB device.
  ☆10Updated 11 years ago
• techie66 / CANSerial
  Serial port emulation over CAN bus
  ☆28Updated 2 years ago
• collin80 / CRC_Nissan
  C# app that shows a simple way to calculate the CRC byte used by some canbus frames in Nissan Leafs
  ☆11Updated 10 years ago
• afterhoursengineering / _CANcrusher_ARM
  Open Source CANbus hacking project.
  ☆13Updated 4 years ago
• jackm / carhack
  Reverse engineering vehicle CAN bus messages
  ☆21Updated 6 years ago
• collin80 / OBD2Scan
  Sketch to scan OBDII with an M2
  ☆12Updated 3 years ago
• p1ne / fdim-controller
  Schematic, PCB and source code for a small Arduino-based controller to make Ford FDIM dash display useful again
  ☆40Updated 3 years ago
• akpc806a / CAN_Bridge
  CAN Bus Bridge / Smart Repeater
  ☆33Updated 6 years ago
• PaulStoffregen / KalmanFilter
  This is a Kalman filter used to calculate the angle, rate and bias from from the input of an accelerometer/magnetometer and a gyroscope.
  ☆14Updated 9 years ago
• JacekGreniger / stm32-vagcanlogger
  VAGCANLOGGER - KW1281 & VW TP 2.0
  ☆31Updated 11 years ago
• krumboeck / usb2can_firmware
  ☆17Updated 9 years ago
• akpc806a / CAN_Logger
  CAN Bus logger with SD card implemented using ChibiOS
  ☆68Updated 5 years ago
• synman / AdaptiveTuner
  Adaptronic Select ECU Tuning Aid
  ☆26Updated 9 years ago