dengyutu / CU-Project-Drawing-RobotLinks
☆18Updated last year
Alternatives and similar repositories for CU-Project-Drawing-Robot
Users that are interested in CU-Project-Drawing-Robot are comparing it to the libraries listed below
Sorting:
- Quick and dirty PIC16F72 programmer using the Raspberry Pi Pico and MicroPython☆33Updated last year
- Multi Channel Configurable PID regulator on M5Stack Core☆46Updated 10 months ago
- A simple cost-effective demo, test, training, board for an oscilloscope made from a Raspberry Pi Pico☆58Updated 7 months ago
- Custom firmware for cheap STC Based Soldering iron using PlatformIO and SDCC 8051 based☆50Updated 2 years ago
- ☆34Updated last year
- 12-Button IR Remote Control☆45Updated 2 years ago
- Reflow Oven from the KMart mini oven☆11Updated 4 months ago
- Hardware designs for Raspberry Pi Pico debug board.☆24Updated last year
- LockDownRadioControl☆47Updated this week
- artificial waveform generator / function generator for DHO800 and DHO900 series (AWG/AFG)☆27Updated this week
- Ultimate Continuity tester☆28Updated 4 years ago
- Dual brushed motor ESC firmware compatible with brushless motor ESCs☆30Updated last year
- Multi-sensor intelligent environmental Monitor☆17Updated last year
- 4 layer version of the Epi 32U4☆57Updated last year
- Battery Health Monitor A compact device for monitoring the State of Health (SoH) and State of Charge (SoC) of lithium batteries. It uses …☆28Updated 3 months ago
- Simple library to exchange data between the 2 cores of a Raspberry Pi Pico under Arduino IDE framework☆27Updated 2 years ago
- Serial port emulation over CAN bus☆30Updated 3 years ago
- Rotary Encoder with USB Interface☆18Updated 10 months ago
- ☆23Updated 2 years ago
- USB controlled nRF24L01+ 2.4GHz Transceiver☆37Updated last year
- Electronic Dummy Load☆47Updated 2 years ago
- ESP32 development board for portable GUI-based designs.☆51Updated 3 months ago
- A generic breakout board for TSSOP20 chips to a SIP header meant for breadboard use☆13Updated 8 months ago
- Arduino library for making seesaw peripherals using Arduino core!☆29Updated 9 months ago
- OpenFAN Micro is open-source open-hardware DIY fan controller for 5V and 12V fans with built in Web GUI and Web API☆18Updated 8 months ago
- Simple Board that can be used as a Mouse Jiggler, a Rubber Ducky, or a Caps Blocker☆37Updated 2 years ago
- Altmode Friend code, STEP and other files☆32Updated 9 months ago
- Simple Logic Probe☆42Updated 2 years ago
- UART and I2C based smart I/O expansion chips based on microcontrollers☆20Updated last week
- Breadboard base with attachment slots for various modules☆36Updated 2 years ago