atc1441 / ATC_stc_solder_iron
Custom firmware for cheap STC Based Soldering iron using PlatformIO and SDCC 8051 based
☆50Updated 2 years ago
Alternatives and similar repositories for ATC_stc_solder_iron:
Users that are interested in ATC_stc_solder_iron are comparing it to the libraries listed below
- ESP3D Firmware for ESP32 based TFT☆44Updated last month
- Dual brushed motor ESC firmware compatible with brushless motor ESCs☆27Updated 10 months ago
- Multi-sensor intelligent environmental Monitor☆17Updated last year
- ESP8266 reflow controller☆23Updated 2 years ago
- ☆50Updated 4 months ago
- Introducing OpenRad, a simple radiation monitoring solution powered by the SBM-20 GM tube and TTGO ESP32 microcontroller. this project of…☆54Updated 3 months ago
- ☆44Updated 3 years ago
- ☆29Updated 2 years ago
- Extend the possibilities of cheap digital power supplies with a WiFi module☆59Updated 11 months ago
- Hot air rework controller for generic 858D / 8586 / 8858 / 852 / 878 / 858 hot air guns from China.☆31Updated 5 years ago
- A reflow Hotplate for DIY SMD assembly☆21Updated 3 months ago
- 12-Button IR Remote Control☆44Updated 2 years ago
- Solder Reflow Plate PCB☆31Updated last year
- Design files for the BAPPR LED buck converter☆41Updated 8 months ago
- Battery Health Monitor A compact device for monitoring the State of Health (SoH) and State of Charge (SoC) of lithium batteries. It uses …☆22Updated last week
- DYI ATX PSU☆35Updated 2 years ago
- Connecting cheap digital calipers to Raspberry Pi and decode readings☆113Updated last month
- Simple USB-C Power Delivery Tester☆37Updated 2 years ago
- Enhancing Nice-Power Bench Power Supplies with ESP8266 Connectivity☆63Updated 3 months ago
- Reflow controller with ESP32 and TFT LCD on board.☆68Updated 2 months ago
- Power Supply Analyzer with USB Interface☆50Updated 2 years ago
- A splitter board (for making a cable splitter) for turning a 5V 3A USB power source to 3 5V 1A USB sources☆31Updated 7 months ago
- A feature-rich reflow Hot-Plate firmware i.e. usable for "Tim's Hot Plate" (https://www.instructables.com/Tims-Hot-Plate/)☆24Updated last year
- Single-Cell Li-Ion, LiPo and LiFePO4 Battery Capacity Tester☆23Updated 2 years ago
- Li-Ion battery charger, based on BQ24060 IC☆42Updated 2 years ago
- A simple cost-effective demo, test, training, board for an oscilloscope made from a Raspberry Pi Pico☆57Updated 4 months ago
- ☆29Updated 3 years ago
- Reflow Oven Controller with EPS32 and Webapp☆40Updated 5 years ago
- Allows to use a ESP32 dev board like a regular Bluetooth dongle☆88Updated 8 months ago
- DIY Reflow Oven, mcu: STM32F103 dev board, Display: Nextion Basic 3.5", PID controller.☆33Updated 3 years ago