Alternatives and similar repositories for PiUPS

Users that are interested in PiUPS are comparing it to the libraries listed below

• reivax-boucoi / Electronic_Load
  DIY Electronic load for DCDC converter characterization
  ☆51Updated 5 years ago
• robin7331 / pixel-pump-mainboard
  ☆51Updated 2 years ago
• BEEMB / Battery-Health-Monitor
  Battery Health Monitor A compact device for monitoring the State of Health (SoH) and State of Charge (SoC) of lithium batteries. It uses …
  ☆32Updated 10 months ago
• microfarad-de / li-charger
  Arduino firmware for a Lithium-Ion battery charger
  ☆42Updated last year
• MarkR42 / malenki-nano
  Speed controller and receiver for small robots
  ☆57Updated 7 months ago
• DurandA / reflow946
  Bluetooth LE temperature controller for the 946C electronic hot plate
  ☆113Updated last year
• YC-Lam / IP5328P-powerbank_design
  a USB power delivery powerbank pcb based on IP5328P chip, feel free to use it
  ☆55Updated last month
• rin67630 / Drok-Juntek-on-steroids
  Extend the possibilities of cheap digital power supplies with a WiFi module
  ☆60Updated last year
• coreWeaver / LC-Meter
  Open Source LC-Meter. All documentation included.
  ☆87Updated 3 years ago
• oxullo / uctester
  Ultimate Continuity tester
  ☆31Updated 5 years ago
• EmanuelBender / HEX_POD
  Multi-sensor intelligent environmental Monitor
  ☆18Updated last year
• CrabLabsLLC / OpenMD
  ☆147Updated last year
• dilshan / 12v-automatic-ups
  12V Automatic UPS system
  ☆45Updated 4 years ago
• solderparty / flexypin
  ☆112Updated last year
• wasspaul / sig_gen
  A simple cost-effective demo, test, training, board for an oscilloscope made from a Raspberry Pi Pico
  ☆60Updated last year
• polihedron / DIY-Reflow-Oven
  DIY Reflow Oven, mcu: STM32F103 dev board, Display: Nextion Basic 3.5", PID controller.
  ☆43Updated 4 years ago
• wagiminator / ADuM3160-USB-Isolator
  2.5kV USB 2.0 Isolator with 200mA Power Supply and Full Speed (12Mbps) Support
  ☆68Updated 3 years ago
• aeonSolutions / PCB-Prototyping-Catalogue
  There are now, a total of 81 hardware electronics on this catalogue for Smart Devices, A.I. enabled. Designed in Kicad, and ready to dow…
  ☆95Updated last year
• knifter / DualPID
  Multi Channel Configurable PID regulator on M5Stack Core
  ☆51Updated last year
• wntrblm / jellyfish-and-starfish
  ☆110Updated 3 years ago
• scheffield / stencil-fix-portable
  ☆69Updated last year
• rallekralle11 / Epi_4L
  4 layer version of the Epi 32U4
  ☆58Updated 2 years ago
• o7-machinehum / Protectli-UPS-Firmware
  Firmware for the Protectli UPS.
  ☆237Updated last year
• wagiminator / ATtiny13-TinyTacho
  Simple RPM-Meter
  ☆57Updated 3 years ago
• CentyLab / PicoPD_Pro
  Repo for PicoPD Pro hardware/software and documentation
  ☆30Updated 6 months ago
• wagiminator / ATtiny814-Power-Analyzer
  Power Supply Analyzer with USB Interface
  ☆56Updated 3 years ago
• microsmt / Microsmt-PNPv3
  Microsmt PNPv3 is a DIY kits for running OpenPnP.
  ☆64Updated this week
• UnexpectedMaker / vacuum-stencil-box
  ☆32Updated 4 years ago
• MariusHeier / magik_solder_paste_stencil_box
  Is it magik? Or is it just a 3d printed box for holding your solder stencils with automatic lifting and vacuum hold down?
  ☆35Updated 4 years ago
• dining-philosopher / litefeeder
  Semi-automatic passive printable/castable feeder for LitePlacer
  ☆59Updated 5 years ago