OpenLockIn / OLIA
A pocket-sized digital lock-in amplifier
☆23Updated last year
Alternatives and similar repositories for OLIA
Users that are interested in OLIA are comparing it to the libraries listed below
Sorting:
- A 0.01Hz-1+MHz low noise amplifier☆21Updated last year
- 5MHz to 2.1GHz RF Synthesizer with modulation capability☆46Updated 2 years ago
- This is a open source hardware (and software) RF Signal Generator using readily available off the shelf-components.☆11Updated 5 years ago
- It started as some general experiments with RF stuff and gradually evolved into a (severely limited) spectrum analyzer.☆41Updated 5 years ago
- A fully fledged lock-in amplifier running at 25 kHz sampling rate @ 12-bit on an Adafruit M4 microprocessor board with an extensive Pytho…☆26Updated 11 months ago
- White and Flicker Noise Sources for LTspice☆22Updated 2 years ago
- Improved multislope ADC☆23Updated 7 months ago
- A low noise nanovoltmeter design files and code☆27Updated 11 months ago
- An ultra-low noise amplifier to measure low-noise LDO/OPA's wide band output noise, and many other interesting measurements. Referred to …☆19Updated last year
- Time domain reflectometer. Includes Hardware, firmware and GUI in Octave. Also a diploma thesis.☆21Updated 3 years ago
- KiCad schematics and ngspice simulations originally published by Holger Vogt☆47Updated last year
- ☆13Updated 2 months ago
- Photodiode transimpedance amplifier, on a one inch diameter circular PCB☆17Updated last year
- Low-noise oscilloscope power rail probe☆46Updated 8 months ago
- 4 port eCal module☆84Updated this week
- Credit card-sized, USB-powered 4 quadrant source-measure unit hardware and firmware☆110Updated 2 months ago
- Benchtop 100Hz to 200kHz LCR meter☆149Updated last year
- ☆22Updated last year
- A tiny 1.3 GHz FET Probe☆31Updated 2 years ago
- FPGA-Based DIY Function Generator☆51Updated 4 years ago
- RF Signal Generator with filtered outputs, modulation features☆14Updated 4 years ago
- Repository for the development of an FPGA based DSP Lock-In Amplifier☆65Updated 2 years ago
- Simple LM399 Voltage Reference board☆25Updated 3 months ago
- Simple GUI plugin for FreeCAD to export current model for EM simulation in OpenEMS☆89Updated last year
- DIY source-measure unit☆153Updated 3 years ago
- A modern replacement for the low contrast HP3457 Multimeter LCD☆28Updated 2 months ago
- PCB Design for H Field and E Field Probes☆27Updated 4 years ago
- Setup a Raspberry Pi for long term measurements☆19Updated 8 months ago
- A Dual-Channel, Low Noise, Modular, 100 kHz Bandwidth, 24-Bit Data Acquisition (DAQ) Device / FFT Signal Analyzer☆12Updated 2 years ago
- 1MHz to 6GHz USB based vector network analyzer☆140Updated 4 years ago