curtisseizert / LowFreqLNA
A 0.01Hz-1+MHz low noise amplifier
☆21Updated last year
Alternatives and similar repositories for LowFreqLNA
Users that are interested in LowFreqLNA are comparing it to the libraries listed below
Sorting:
- A low noise nanovoltmeter design files and code☆27Updated 11 months ago
- ☆13Updated 2 months ago
- Low-noise oscilloscope power rail probe☆46Updated 8 months ago
- A modern replacement for the low contrast HP3457 Multimeter LCD☆28Updated 2 months ago
- 4 port eCal module☆84Updated 2 months ago
- A tiny 1.3 GHz FET Probe☆31Updated 2 years ago
- It started as some general experiments with RF stuff and gradually evolved into a (severely limited) spectrum analyzer.☆40Updated 5 years ago
- Improved multislope ADC☆23Updated 7 months ago
- White and Flicker Noise Sources for LTspice☆22Updated 2 years ago
- 5MHz to 2.1GHz RF Synthesizer with modulation capability☆46Updated 2 years ago
- Instrumentation datalogger for metrology applications with TEC controller function☆16Updated 2 years ago
- A pocket-sized digital lock-in amplifier☆23Updated last year
- An ultra-low noise amplifier to measure low-noise LDO/OPA's wide band output noise, and many other interesting measurements. Referred to …☆19Updated last year
- ☆22Updated last year
- A clone of the LTZ1000 reference board from the HP 3458A 8.5-digit multimeter☆12Updated 7 years ago
- RF Signal Generator with filtered outputs, modulation features☆14Updated 4 years ago
- Keithley 2000-SCAN solid-state relay replacement☆11Updated 5 months ago
- This is a open source hardware (and software) RF Signal Generator using readily available off the shelf-components.☆11Updated 5 years ago
- Simple LM399 Voltage Reference board☆25Updated 3 months ago
- 2GHz single-ended active probe design☆127Updated 10 months ago
- 1MHz to 6GHz USB based vector network analyzer☆139Updated 4 years ago
- Vector Network Analyzer based on the STM32F103C8T6 bluepill☆84Updated 4 years ago
- Setup a Raspberry Pi for long term measurements☆19Updated 8 months ago
- An experimental GPSDO using an STM32 MCU and a u-blox Neo-M8 GNSS module.☆80Updated 3 years ago
- Jim Williams Pulse Generator for oscilloscope rise time measurements☆28Updated 3 years ago
- Credit card-sized, USB-powered 4 quadrant source-measure unit hardware and firmware☆110Updated 2 months ago
- Work towards an open-source multi-GHz sampling oscilloscope design☆36Updated 5 years ago
- A Dual-Channel, Low Noise, Modular, 100 kHz Bandwidth, 24-Bit Data Acquisition (DAQ) Device / FFT Signal Analyzer☆12Updated 2 years ago
- A Dual-Channel, 24-Bit, 256 kS/s Real-Time Hi-Speed USB 2.0 Data Acquisition (DAQ) Device based on STM32H7☆29Updated 2 years ago
- Hardware and firmware for the DIY SMU project: Source Measure Unit☆14Updated 3 years ago