MagnusThome / ESP32S3RETLinks
CAN Reverse engineering tool for ESP32-S3 based boards
☆14Updated last year
Alternatives and similar repositories for ESP32S3RET
Users that are interested in ESP32S3RET are comparing it to the libraries listed below
Sorting:
- ☆20Updated 7 months ago
- DS2 K-line library for Arduino and ESP32☆52Updated 6 months ago
- Hardware - CAN enabled small input / output expansion board. Switch panels, steering wheel buttons/knobs, etc.☆44Updated 2 months ago
- An Arduino library for reading OBD-II data from your car over CAN bus☆53Updated last year
- Parse CAN logs and visualize data streams on plot☆74Updated last year
- EMS boards powered by Speeduino☆12Updated 2 months ago
- Monitor Canbus traffic☆130Updated 5 months ago
- Hardware - dingoPDM is an open source, affordable automotive PDM (Power Distribution Module). Pre-assembled and tested units are availabl…☆89Updated 3 weeks ago
- Standalone ECU designed for Speeduino and RusEFI firmware.☆48Updated last year
- ☆61Updated 2 weeks ago
- Hello world sample code for the ESP32-S3 dual CAN bus development board☆21Updated 3 months ago
- This repo for using your Arduino with MCP2515 CAN Interface and CANHacker software☆55Updated 4 years ago
- Bridge between Wifi and CAN. Minimal variant of the ESP32RET. Using ESP32s3☆34Updated last year
- CAN Reverse engineering tool for ESP32 based boards (specifically EVTV ESP32Due)☆327Updated 9 months ago
- Very hacky project that talks to the Nissan Leaf BMS (aka LBC) and to the VW CAN bus☆61Updated 6 months ago
- Speeduino compatible engine control unit (ECU) based around black STM32F407VET6 board.☆49Updated last year
- ESP32 slcan compatible device☆101Updated 4 years ago
- ESP32-IDF based BLE<->ISO-TP bridge targeting Macchina A0 hardware☆39Updated 2 years ago
- A ESP32 based CAN interface for your webbrowser☆27Updated 4 years ago
- CAN bus analyzing and simulation GUI tool for Windows.☆75Updated 2 weeks ago
- Wideband Lambda Controller with Bosch CJ125 and CAN-Bus Interface☆31Updated last year
- Wideband Lambda Controller with Bosch CJ125☆42Updated last year
- A Vehicle Control Unit for Electric Vehicle Conversion Projects based on an STM32F107. Software based on the Openinverter Project.☆187Updated this week
- ☆44Updated 3 years ago
- Reverse Engineering of the BMW SBox for use in ev conversion projects☆12Updated 2 years ago
- Arduino / ESP / RPi Pico library integrating the proprietary VAG Key-Word 1281 protocol (KWP1281/KW1281)☆62Updated 11 months ago
- Provide LIN-Master functions (write and request LIN-Frames via hardware UART☆41Updated last year
- CAN bus node for Hyundai Ioniq motor CAN☆11Updated 2 years ago
- ☆17Updated 3 years ago
- MCP2515 CAN interface library for using on esp32/esp8266☆65Updated 4 years ago