LenShustek / M-NET-SnifferLinks
Hardware and software to capture and decode the Mitsubishi M-NET HVAC protocol
☆50Updated 10 years ago
Alternatives and similar repositories for M-NET-Sniffer
Users that are interested in M-NET-Sniffer are comparing it to the libraries listed below
Sorting:
- ESP8266 - based Vaillant boiler E-Bus monitor, temperature/pressure publishing to Narodmon.ru☆46Updated 3 years ago
- A complete secure access control and alarm panel system using ESP32 modules, including firmware, management back end, and PCB and case de…☆60Updated 3 weeks ago
- ESP32 Power Over Ethernet board with 3000VDC Galvanic insulation☆127Updated last week
- Documentaion of Mitsubishi CN105 Protocol of Ecodan Air Source Heat Pumps☆72Updated last year
- ☆31Updated 4 years ago
- An M-bus master that poll a meter and logs data to an MQTT server☆52Updated 9 years ago
- BK7231T/BK7231N python-based flasher (both read and write), used mostly to flash https://github.com/openshwprojects/OpenBK7231T_App☆80Updated last year
- Automate your home with GoWired open source modules designed for wired communication.☆41Updated 2 years ago
- TI CC2652R w/ USB-UART in the ubiquitous "stick" form factor☆84Updated 5 years ago
- ☆27Updated this week
- A library for controlling Midea home appliances using the UART protocol.☆94Updated last month
- An interface for the Eastron SDM/Modbus smart meter series.☆74Updated 6 years ago
- Single relay with ds18b20 sensor for TI cc2530 and Sonoff Zigbee☆66Updated last year
- Open-source Heatpump Monitor☆78Updated last year
- Arduino-based controller for Daikin Altherma heat pumps. The controller connect to the Altherma heat pump via P1/P2 bus, has a built-in w…☆62Updated 6 months ago
- Zigbee Ultra Low Power IOT Development Board☆85Updated 2 years ago
- Livolo light switch firmware☆22Updated 8 years ago
- Daikin P1/P2 Raspberry Pi hat☆12Updated 7 months ago
- Simple ESP32 with native ethernet using LAN8720 phy, Arduino compatible☆29Updated 3 years ago
- Node-Red node for M-Bus protocol☆12Updated 4 months ago
- Efficient, portable and lightweight library for Internet of Things payload decoding.☆190Updated 3 weeks ago
- Add Home Assistant support to your RDTech power supply☆50Updated 9 months ago
- A Modbus RTU (RS-485) to MQTT Gateway (based on ESP32)☆93Updated last year
- Growatt Inverter monitoring via MQTT using ESP8266 modbus interface☆69Updated 5 years ago
- Arduino library and hardware shield to send and receive data from Opentherm devices☆181Updated 2 years ago
- Generic library for any voltage and current sensors. Interrupt based, implements a zero cross detector and phase-locked loop for better p…☆27Updated 9 years ago
- Open design of stick for Midea-compatible climate devices (Midea, Electrolux and others).☆54Updated 4 years ago
- Programmer for CC2538 backdoor UART bootloader☆46Updated 11 years ago
- EmonTx V3.4.x Hardware and older discreet firmware, see EmonTxV3CM repo for latest☆66Updated 3 months ago
- EZSP Firmware☆25Updated 4 years ago