Arnold-n / P1P2MQTTLinks
Monitor and control Daikin/Rotex Altherma heat pumps from Home Assistant directly via the 2-wire P1/P2 thermostat interface. Also enables reading other Japanese Home Bus System based standards, a.o. Hitachi H-link, Hisense H-NET, MHI, Daikin DIII-NET (F1/F2) bus, Mitsubishi M-Net bus, Toshiba TCC-Link, Panasonic/Sanyo SIII-Net, Haier, and York.
☆430Updated 3 months ago
Alternatives and similar repositories for P1P2MQTT
Users that are interested in P1P2MQTT are comparing it to the libraries listed below
Sorting:
- Monitor your Daikin Altherma / ROTEX heat pump with ESP32☆463Updated last month
- Arduino-based controller for Daikin Altherma heat pumps. The controller connect to the Altherma heat pump via P1/P2 bus, has a built-in w…☆62Updated 6 months ago
- ESP8266 firmware to read and control EMS and Heatronic compatible equipment such as boilers, thermostats, solar modules, and heat pumps☆313Updated 4 years ago
- ESP8266 and ESP32 compatible firmware to read, interpret and publish data to MQTT from smart electrical meters, both DLMS and DSMR is sup…☆434Updated last week
- ESPHome custom component for reading P1 data from electricity meters.☆321Updated 10 months ago
- Reads and writes data (e.g. power, mode, fan status etc.) from/to a Mitsubishi Heavy Industries (MHI) air conditioner (AC) via SPI contro…☆338Updated last month
- Open source alternative for Panasonic air condition wifi adapters that works locally without the Comfort Cloud☆331Updated 3 weeks ago
- Controller for HmIP-VdMot actuators☆70Updated 7 months ago
- Smart Electric Vehicle Charging Station (EVSE)☆154Updated last week
- An ESP32 based 8 channels motor controller (to replace Homematic IP Floor Heating Actuator)☆111Updated 6 months ago
- A ESP8266 devkit firmware for the Nodoshop version of the Opentherm Gateway (OTGW)☆166Updated this week
- Firmware for ESP8266 allowing eBUS communication for ebusd (https://github.com/john30/ebusd)☆158Updated last year
- Daikin Online/Mobile Controller Wire Harness☆32Updated 6 years ago
- ☆80Updated 5 years ago
- Arduino-based WiFi/MQTT controller for wireless operation of a Mitsubishi Heavy Industries air conditioner through its serial CNS port☆146Updated 2 years ago
- ESPHome component to read out DLMS smart meters via M-Bus☆121Updated last year
- ESP32 firmware to read and control EMS and Heatronic compatible equipment such as boilers, thermostats, solar modules, and heat pumps☆878Updated last week
- Panasonic Aquarea air-water H, J, K and L series protocol decrypt☆338Updated last week
- Use official Victron BLE endpoint for fetching data from Victron devices via Bluetooth LE via ESPHome.☆354Updated last month
- Interact with Zehnder Comfoair with esp32☆143Updated 2 months ago
- Data provider for smartmeter watermeter.☆259Updated this week
- Esphome component for Deye 3 phase inverters for Home Assistant☆201Updated last year
- Esphome components for nibe heat pumps☆104Updated this week
- Software for an esp8266 nodemcu to read data from APS inverters.☆143Updated 4 months ago
- esphome firmware for esp32_8ch_motor_shield☆57Updated 2 months ago
- Documentaion of Mitsubishi CN105 Protocol of Ecodan Air Source Heat Pumps☆72Updated last year
- Readout of EMS protocol datagrams and transfer of data to Domoticz via Arduino☆90Updated 4 years ago
- Mitsubishi Electric CN105 to MQTT with ESP8266/ESP32 module☆104Updated last month
- ebusd configuration files☆250Updated 3 months ago
- ESPHome configuration to drive Zehnder ComfoAir devices.☆74Updated 3 weeks ago