budulinek / arduino-altherma-controllerLinks
Arduino-based controller for Daikin Altherma heat pumps. The controller connect to the Altherma heat pump via P1/P2 bus, has a built-in webserver for configuration (of the controller itself). Integration to Loxone home automation system via UDP protocol, allows you to monitor and control your Altherma heat pump.
☆57Updated last week
Alternatives and similar repositories for arduino-altherma-controller
Users that are interested in arduino-altherma-controller are comparing it to the libraries listed below
Sorting:
- Monitor and control Daikin/Rotex Altherma heat pumps from Home Assistant directly via the 2-wire P1/P2 thermostat interface. Also enables…☆384Updated last week
- Firmware for ESP8266 allowing eBUS communication for ebusd (https://github.com/john30/ebusd)☆156Updated last year
- ESPHome Component for Daikin Mini-Splits using the S21 serial port.☆91Updated last month
- ☆15Updated last month
- Documentaion of Mitsubishi CN105 Protocol of Ecodan Air Source Heat Pumps☆69Updated 11 months ago
- Arduino-based WiFi/MQTT controller for wireless operation of a Mitsubishi Heavy Industries air conditioner through its serial CNS port☆144Updated 2 years ago
- Protocol description of the serial communication channel of Samsung airconditioners.☆84Updated 10 months ago
- Daikin Online/Mobile Controller Wire Harness☆31Updated 5 years ago
- ☆30Updated 3 years ago
- ☆93Updated last month
- An ESP32 based 8 channels motor controller (to replace Homematic IP Floor Heating Actuator)☆103Updated 3 weeks ago
- Readout of EMS protocol datagrams and transfer of data to Domoticz via Arduino☆90Updated 4 years ago
- Open-source firmware for STM32 co-processor on the Shelly Dimmer.☆55Updated last year
- Controller for HmIP-VdMot actuators☆60Updated last month
- ZigBee CC2652P2 Ethernet Coordinator☆33Updated 2 years ago
- ESPHome component to monitor a Solax X1 mini via RS485☆40Updated 3 weeks ago
- Arduino library and hardware shield to send and receive data from Opentherm devices☆176Updated 2 years ago
- ESP8266 firmware to read and control EMS and Heatronic compatible equipment such as boilers, thermostats, solar modules, and heat pumps☆312Updated 3 years ago
- ESPHome component to simulate the current clamp to control the Soyosource GTN1200 limiter☆90Updated 3 weeks ago
- A ESP8266 devkit firmware for the Nodoshop version of the Opentherm Gateway (OTGW)☆158Updated last year
- ESPHome Modbus Server component☆45Updated 2 years ago
- A library for controlling Midea home appliances using the UART protocol.☆88Updated 2 months ago
- Stream server (serial-to-wifi bridge) for ESPHome☆246Updated last year
- A repository of custom esphome components☆101Updated this week
- ☆38Updated 9 months ago
- RFLink for ESP, with MQTT client☆162Updated 2 months ago
- Custom Component for ESPHome enabling Serial over TCP☆47Updated last year
- Modbus RTU to MQTT Gateway☆90Updated last month
- Reads and writes data (e.g. power, mode, fan status etc.) from/to a Mitsubishi Heavy Industries (MHI) air conditioner (AC) via SPI contro…☆324Updated last month
- ☆25Updated last year