vvvrrooomm / victronLinks
VictronConnect protocol implementation
☆42Updated last year
Alternatives and similar repositories for victron
Users that are interested in victron are comparing it to the libraries listed below
Sorting:
- Victron bluetooth and serial communication at a python script. With MQTT and HomeAssistant support.☆130Updated last year
- A Python API to parse Victron Instant Readout BLE advertisements☆141Updated 3 months ago
- Code to read the VE.Direct-Protocol from serial into a value array. Uses a non-blocking read loop and does checksum verification before a…☆129Updated 3 years ago
- ☆30Updated 3 years ago
- A node red based dashboard for most EPEver/EPSolar solar charge controllers.☆68Updated last year
- EPSolar Solar Charge Controller to MQTT☆43Updated 3 years ago
- Program to read out and display data from xiaoxiang Smart BMS over Bluetooth Low Energy☆113Updated 11 months ago
- This project is for connecting to EPEver charge controllers over WiFi for viewing running stats and also allows automatic posting of them…☆74Updated 11 months ago
- Read data from victron mppt and transport to mqtt server☆42Updated 3 years ago
- Decompiling the VictronConnect app☆59Updated 3 years ago
- Lightweight arduino library to read basic data using the VE.Direct protocol from Victron Energy☆93Updated 2 years ago
- M-Bus gateway with web server based on ESP8266 NodeMCU☆27Updated 3 months ago
- Python module for Daly BMS devices☆100Updated last year
- Simple VE.Direct reader for Python☆100Updated 4 years ago
- An Actisense NGT-1 compatible NMEA 2000 USB gateway for the SH-ESP32☆32Updated last year
- ATtiny85 based LoRa atmospheric sensor board with BME280☆28Updated 6 years ago
- Just the Arduino Library for Overkill Solar BMSs☆37Updated 2 years ago
- ☆41Updated 3 years ago
- MQTT 433.92 MHz radio-frequency device gateway☆137Updated 2 years ago
- Use a esp32 to push VE.Direct ASCII messages to a MQTT server☆61Updated last year
- Python code to monitor and log battery data☆107Updated last year
- An arduino sketch to connect the EPSolar/EPEver Tracer A/B Series (RS-485 Modbus) to an ESP8266 and monitor using the Blynk mobile app - …☆59Updated 4 years ago
- To measure battery voltage, engine RPM, fuel level and exhaust teperature with an ESP32 and send it to a NMEA 2000 network.☆63Updated 3 years ago
- Binary protocol parser for the smart BMS from LTT Power☆56Updated 2 years ago
- Efficient, portable and lightweight library for Internet of Things payload decoding.☆170Updated last week
- Sailor Hat for ESP32 hardware☆47Updated 9 months ago
- Simple library for Arduino (ESP32) to control a Chinese diesel heater through 433 MHz RF☆98Updated 4 years ago
- ESP8266 Connector to get Daly / XENES / HI-BMS / BullTron BMS Data into MQTT systems☆172Updated 3 months ago
- An arduino sketch to connect the EPSolar/EPEver Tracer A/B Series (RS-485 Modbus) to an ESP8266 and monitor using the Blynk mobile app.☆65Updated 6 years ago
- ESPHome component to simulate the current clamp to control the Soyosource GTN1200 limiter☆90Updated 3 weeks ago