Moki38 / vedirectLinks
Nodejs Victron Ve.Direct npm module
☆11Updated 9 years ago
Alternatives and similar repositories for vedirect
Users that are interested in vedirect are comparing it to the libraries listed below
Sorting:
- ☆17Updated last year
- Sailor Hat for ESP32 hardware☆48Updated last year
- A node red based dashboard for most EPEver/EPSolar solar charge controllers.☆68Updated 2 years ago
- Code to read the VE.Direct-Protocol from serial into a value array. Uses a non-blocking read loop and does checksum verification before a…☆130Updated 4 years ago
- This repository shows how to build a Seatalk Autopilot Remote Control device based on an Arduino ProMicro and a simple 433 MHz KeyFob.☆67Updated 5 months ago
- Universal Signal K sensor framework for the ESP32 platform☆186Updated 3 months ago
- npm module for Renogy Rover MPPT solar controller.☆30Updated 7 years ago
- ☆45Updated last year
- Documents and Code for use with Heltec CubeCell LoraWAN Node Boards, Capsule, and Modules☆30Updated 6 years ago
- Arduino project to control webasto heater via W-bus☆48Updated 7 years ago
- ☆60Updated last year
- EPSolar Solar Charge Controller to MQTT☆43Updated 4 years ago
- TTGO-T-Beam Arduino Car Tracker - ESP32 + LoRa + GPS + GSM (optional)☆188Updated last year
- Read the Bluetooth advertised data from a Victron Battery Monitor or Solar Charger, without (or in addition to) using the VictronConnect …☆53Updated 5 months ago
- Lightweight arduino library to read basic data using the VE.Direct protocol from Victron Energy☆95Updated 2 years ago
- LoFence is a LoRaWAN capable IoT electric fence monitoring system running on the The Things Network.☆136Updated 3 years ago
- AS3935 and ESP8266 based Franklin Lightning Detector☆45Updated 9 months ago
- Inherited object for use NMEA2000 with ESP32 boards☆88Updated last year
- WASN LoRaWan Devices Getting Started Guide☆22Updated 2 years ago
- This is code, PCB and enclosure design for an ESP32_CAM based wildlife camera☆38Updated 4 months ago
- A simple Go based monitoring tool for Victron Multiplus devices☆44Updated last year
- ☆41Updated 4 years ago
- TTNMapper on the TTGO T-Beam☆109Updated 4 years ago
- support for the VE.Direct serial protocol supported by many Victron Energy products☆22Updated last year
- To measure battery voltage, engine RPM, fuel level and exhaust teperature with an ESP32 and send it to a NMEA 2000 network.☆65Updated 3 years ago
- M5Stack Tough (ESP-32) Sailing Instruments Display and Autopilot Control☆119Updated 9 months ago
- An Actisense NGT-1 compatible NMEA 2000 USB gateway for the SH-ESP32☆32Updated 2 years ago
- OGN Tracker implementation on ESP32 devices☆65Updated 2 years ago
- An arduino sketch to connect the EPSolar/EPEver Tracer A/B Series (RS-485 Modbus) to an ESP8266 and monitor using the Blynk mobile app - …☆61Updated 4 years ago
- Raspberry Pi 7" touchscreen for Venus OS (also HDMI)☆52Updated 7 months ago