Alternatives and similar repositories for arduino_focus_rs_gauges

Users that are interested in arduino_focus_rs_gauges are comparing it to the libraries listed below

• upiir / custom_boost_gauge_esp32
  Custom Turbo Boost Gauge using ESP32S3 with Round Waveshare IPS Display
  ☆113Updated 10 months ago
• Tjeerdie / SPECTRE
  Speeduino compatible engine control unit (ECU) based around black STM32F407VET6 board.
  ☆50Updated last year
• mck1117 / wideband
  ☆57Updated 3 weeks ago
• dvjcodec / SCG-ECU-2.0-STM32F407-8x8
  Standalone ECU designed for Speeduino and RusEFI firmware.
  ☆40Updated last year
• omarKmekkawy / Arduino_CANHacker
  This repo for using your Arduino with MCP2515 CAN Interface and CANHacker software
  ☆53Updated 3 years ago
• garagetinkering / esp32-canbus-sniffer
  ☆55Updated 6 months ago
• upiir / arduino_gear_indicator
  Arduino UNO Gear Indicator for Manual Transmission using Hall Sensors
  ☆57Updated last year
• designer2k2 / EMUcan
  ECUMaster EMU CAN Stream Reader Arduino Library
  ☆34Updated 2 weeks ago
• oelprinz-org / BL49SP
  Wideband Lambda Controller with Bosch CJ125
  ☆38Updated last year
• MielArrojado / speeduino-ardugauge
  An OLED gauge for the Speeduino ECU. Uses UART (secondary serial) for communication.
  ☆37Updated 2 years ago
• kjellegafvelin / SimpleDyno
  ☆26Updated 2 years ago
• speeduino / kicad-parts
  A library of kicad symbols and footprints for parts used across the Speeduino boards
  ☆17Updated last year
• MagnusThome / esp32_obd2
  An Arduino library for reading OBD-II data from your car over CAN bus
  ☆43Updated last year
• pazi88 / 8Ch-EGT
  8Ch EGT sensor board to be used with aftermarket ECUs
  ☆31Updated last year
• turboedge / SpeedyBoards
  EMS boards powered by Speeduino
  ☆88Updated 7 months ago
• voltlog / CanLite
  ESP32 based CAN development board
  ☆174Updated 3 years ago
• VolosR / TDisplayDashboard
  ☆133Updated 2 years ago
• rusefi / rusefi-hardware
  ☆26Updated this week
• dvjcodec / SCG-ECU-1.0
  Standalone ECU designed for Speeduino firmware
  ☆39Updated 5 years ago
• Cellgalvano / ESP32_CANViewer
  A ESP32 based CAN interface for your webbrowser
  ☆24Updated 4 years ago
• handmade0octopus / ds2
  DS2 K-line library for Arduino and ESP32
  ☆48Updated 2 months ago
• DeeEmm / DIY-Flow-Bench
  Volumetric flow bench based on ESP32 and MAF sensor.
  ☆31Updated 4 months ago
• Autohome2 / dxControl-Gears
  ☆22Updated 7 years ago
• speeduino / Ardu-Stim
  ☆124Updated 4 months ago
• analoghan / CAN_Gauges
  Arduino/Teensy CAN Gauges with OLED displays
  ☆16Updated 7 years ago
• s-marley / CarLights
  Code and schematics for connecting a 5V Arduino to 12V vehicle signals
  ☆24Updated 4 years ago
• dvjcodec / ECUTeen_3.5
  ECU designed for Speeduino firmware
  ☆32Updated 5 years ago
• upiir / arduino_dashboard
  Car Dashboard using Arduino Leonardo, OBDII to UART adapter and Intelligent Nextion Display
  ☆30Updated 8 months ago
• corygrant / dingoPDM
  Hardware - dingoPDM is an open source, affordable automotive PDM (Power Distribution Module). Pre-assembled and tested units are availabl…
  ☆80Updated last week
• MagnusThome / ESP32S3RET
  CAN Reverse engineering tool for ESP32-S3 based boards
  ☆13Updated last year