upiir / arduino_gear_indicatorLinks
Arduino UNO Gear Indicator for Manual Transmission using Hall Sensors
☆61Updated last year
Alternatives and similar repositories for arduino_gear_indicator
Users that are interested in arduino_gear_indicator are comparing it to the libraries listed below
Sorting:
- Connecting cheap digital calipers to Raspberry Pi and decode readings☆123Updated 7 months ago
- Car Dashboard using Arduino Leonardo, OBDII to UART adapter and Intelligent Nextion Display☆32Updated 11 months ago
- Custom Turbo Boost Gauge using ESP32S3 with Round Waveshare IPS Display☆117Updated last year
- Arduino TPMS - Tire Pressure Monitoring System☆90Updated 2 months ago
- This is V4 of the Arduino Spot Welder. An Arduino based Spot Welder for battery welding☆95Updated 5 months ago
- Ford Focus RS gauges with Arduino UNO☆65Updated last year
- ☆60Updated 9 months ago
- A CNC Pendant on ESP32 board, with LCD, WiFi and SD card☆78Updated last month
- Multi-sensor intelligent environmental Monitor☆16Updated last year
- Battery Health Monitor A compact device for monitoring the State of Health (SoH) and State of Charge (SoC) of lithium batteries. It uses …☆30Updated 6 months ago
- ESP3D Firmware for ESP32 based TFT☆48Updated 5 months ago
- Electronic Leadscrew For Lathe☆61Updated 2 years ago
- 4 layer version of the Epi 32U4☆58Updated last year
- Arduino UNO with Round LCD IPS Display☆68Updated last year
- A variant of the MP2 electronic speed control with DFNW MOSFETs☆23Updated last year
- Simple RPM-Meter☆57Updated 2 years ago
- A wireless GRBL CNC pendant project based on the ESP32 micro-controller☆54Updated 4 years ago
- Battery monitor for Aibo☆22Updated 3 years ago
- Multi Channel Configurable PID regulator on M5Stack Core☆48Updated last year
- Custom firmware for cheap STC Based Soldering iron using PlatformIO and SDCC 8051 based☆50Updated 2 years ago
- Dual brushed motor ESC firmware compatible with brushless motor ESCs☆32Updated last year
- ESP8266 reflow controller☆26Updated 3 years ago
- ☆140Updated 2 years ago
- Pendants for controlling FluidNC CNC firmware☆43Updated 6 months ago
- ☆107Updated 2 years ago
- DIY Printed small PCB CNC for fast Prototyping☆47Updated 4 years ago
- A low cost stepper motor analyzer that uses wireless BLE link to display the data in real time on a Windows/Mac/Linux PC.☆54Updated 2 years ago
- ☆44Updated 3 years ago
- Mach3 write to Arduino UNO to view X & Y DRO and read external button via ModBus protocol☆12Updated 6 years ago
- List of controllers supported by grblHAL☆54Updated 6 months ago