JOGAsoft / EBC-controllerLinks
A linux software to control ZTE Tech EBC A-series battery testers and electronic loads
☆30Updated 2 years ago
Alternatives and similar repositories for EBC-controller
Users that are interested in EBC-controller are comparing it to the libraries listed below
Sorting:
- Information gathered on the Uni-T UT210E multimeter.☆167Updated 2 years ago
- 150W Electronic load / Battery discharge capacity tester PX-100 v2.70 protocol and control software. May be compatible with some DL24 ver…☆126Updated last year
- An alternative firmware for the Riden WiFi module that provides Modbus TCP and SCPI support as well as a web interface.☆29Updated last month
- Add Home Assistant support to your RDTech power supply☆50Updated 7 months ago
- RD6006 Python module☆106Updated last year
- Riden RD6006 Firmware Update Flash Tool☆83Updated 4 months ago
- Example code to communicate with Huawei R4850G2 Power Supply via CAN☆75Updated last year
- A python gui to display & control DPS5005 power supply☆78Updated 2 years ago
- Arduino Interface for cheap 2.4ghz RF enabled Solar Micro Inverters☆66Updated 2 years ago
- rdserialtool - RDTech UM/DPS/RD series device interface tool☆99Updated 3 years ago
- ☆54Updated 6 months ago
- Software, hardware and protocol information for the Eltek Flatpack2.☆50Updated 6 years ago
- A intelligent Power supply with micro control and logging, for very long test (battery cycles)☆72Updated 5 years ago
- Arduino library for communicating with Daly BMSs over UART☆113Updated 2 years ago
- Python code to read status from the DPS-1200FB power supply☆142Updated 7 years ago
- ☆16Updated 3 years ago
- JBD BMS Linux utility☆68Updated 5 months ago
- A python library for Riden RD power supplies☆63Updated last year
- Open-Source firmware for the ZPB30A1 electronic load (WIP)☆51Updated 7 years ago
- New firmware for the FNIRSI-1013D osciloscope.☆145Updated 8 months ago
- Isolated current, voltage and SOC monitor for battery banks up to 85V☆54Updated 2 years ago
- Arduino code to read Smart Battery data from laptop battery packs using SMBus/I2C☆114Updated 11 years ago
- Alternative firmware for the BST900 boost converter for serial control☆20Updated 4 years ago
- Library for working with JBD BMS☆75Updated last year
- Python library and CLI tool for RC3563 battery impedance meter.☆10Updated 3 years ago
- fygen is a Python library for Feeltech Signal Generators (FY2300, FY6600, FY6800, FY6900 and more)☆101Updated 8 months ago
- A linux software to control ZTE Tech EBC A-series battery testers and electronic loads, this fork adds support for EBC-A20☆13Updated last year
- ESP32 Bluetooth to UART Bridge (Replaces HC-05)☆68Updated 6 years ago
- tinyCurrent – a uCurrent Gold Clone/ Derivative☆142Updated 5 years ago
- Control DP-1200FB using an Arduino over the i2c bus☆86Updated 3 years ago