openhp / HeatPumpControllerLinks
The Valden Heat Pump controller is a platform to precisely control heat pumps
☆149Updated 4 years ago
Alternatives and similar repositories for HeatPumpController
Users that are interested in HeatPumpController are comparing it to the libraries listed below
Sorting:
- diyBMS v4 code for the ESP32 and new controller hardware☆219Updated last month
- diy BMS version 4 for Nissan Leaf cells☆20Updated 4 years ago
- Software for diyBMS v4☆152Updated last year
- JBD BMS Linux utility☆70Updated 7 months ago
- Example code to communicate with Huawei R4850G2 Power Supply via CAN☆78Updated last year
- Extend the possibilities of cheap digital power supplies with a WiFi module☆59Updated last year
- CHPC: Cheap Heat Pump Controller☆55Updated 4 years ago
- Arduino library for communicating with Daly BMSs over UART☆113Updated 2 years ago
- A python library for Riden RD power supplies☆65Updated last year
- Just the Arduino Library for Overkill Solar BMSs☆37Updated 3 years ago
- Arduino Uno Code for EV Charger☆160Updated last year
- Program to read out and display data from xiaoxiang Smart BMS over Bluetooth Low Energy☆117Updated last year
- An Arduino M0 based controller for Webasto C/E Diesel Water Heaters☆61Updated last month
- Isolated current, voltage and SOC monitor for battery banks up to 85V☆54Updated 2 years ago
- Arduino Interface for cheap 2.4ghz RF enabled Solar Micro Inverters☆66Updated 2 years ago
- An opensource solution for connecting OBD2 straight to the Nissan Leaf battery☆66Updated last year
- ESP32 Smart Solar Charger - the Open Solar Project☆285Updated 2 years ago
- RD6006 Python module☆106Updated last year
- SimpBMS Documentation☆91Updated 3 years ago
- Riden RD6006 Firmware Update Flash Tool☆83Updated 5 months ago
- Library for working with JBD BMS☆76Updated last year
- 150W Electronic load / Battery discharge capacity tester PX-100 v2.70 protocol and control software. May be compatible with some DL24 ver…☆126Updated last year
- Arduino project to control webasto heater via W-bus☆52Updated 7 years ago
- The Service Display is a open source tool, that allows you to connect Valden Heat Pump Controller to get maximum available information fr…☆16Updated 4 years ago
- ESP32 based CAN development board☆179Updated 3 years ago
- Add Home Assistant support to your RDTech power supply☆50Updated 9 months ago
- Software, hardware and protocol information for the Eltek Flatpack2.☆53Updated 6 years ago
- ☆13Updated 4 years ago
- ☆63Updated 6 years ago
- ☆57Updated 7 months ago