russery / can_bridgeLinks
a bridge between two or more CAN buses
☆15Updated 8 years ago
Alternatives and similar repositories for can_bridge
Users that are interested in can_bridge are comparing it to the libraries listed below
Sorting:
- Command-line tool to flashing devices by CAN-BUS☆85Updated 5 years ago
- ☆114Updated last year
- CAN_Interface for ESP32 (Cannelloni Protocol)☆56Updated 4 years ago
- CAN Bus logger with SD card implemented using ChibiOS☆71Updated 6 years ago
- CAN Bus Bridge / Smart Repeater☆37Updated 4 months ago
- Generalized Electric Vehicle Control Unit☆118Updated 3 years ago
- Hardware - dingoPDM is an open source, affordable automotive PDM (Power Distribution Module). Pre-assembled and tested units are availabl…☆84Updated this week
- FlexCAN (CAN 2.0 / CANFD) Library for Teensy 3.x and 4.0☆217Updated last year
- 8Ch EGT sensor board to be used with aftermarket ECUs☆33Updated last year
- Generalized Vehicle Reverse Engineering Tool - firmware for Arduino Due based boards☆104Updated 6 years ago
- Firmware for the CANalyze hardware.☆69Updated last year
- An open source TCM for Daimlers 722.6 gearbox. Resource repository☆116Updated 10 months ago
- This is project SuperCAN. An open source USB to CAN-FD protocol.☆88Updated 3 weeks ago
- Peak and hold injector driver for low-Z injectors.☆14Updated 2 years ago
- USB-CAN(SocketCAN) sketch for Arduino CAN-BUS shield☆136Updated 3 years ago
- This is an Open Source Hardware USB to CAN-FD Interface☆69Updated 6 months ago
- ☆22Updated 7 years ago
- Firmware to support gs_usb on most STM32 devices☆46Updated 5 months ago
- microRusEfi board for rusEfi ECU☆77Updated 2 weeks ago
- Wideband Lambda Controller with Bosch CJ125 and CAN-Bus Interface☆29Updated last year
- CAN bus analyzing and simulation GUI tool for Windows.☆69Updated 6 months ago
- ESP32 slcan compatible device☆101Updated 3 years ago
- An Arduino based LINBUS stack and signal interceptor/injector.☆193Updated 6 years ago
- Eagle schematics of inverter main board, sensor boards and gate drivers☆71Updated 3 years ago
- ☆59Updated 3 weeks ago
- Hardware design files for the CANtact Pro☆73Updated 5 years ago
- ☆18Updated 4 months ago
- Arduino library to add dual LIN support on SAM3X based boards with a TJA1021/TJA1027 transceiver☆115Updated 6 years ago
- ☆22Updated 2 years ago
- Designs for the Macchina M2☆93Updated 4 years ago